User manual KENWOOD ESP107

[. . . ] Never use ground coffee or teabags in the pod filter. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Only use the appliance for its intended domestic use. [. . . ] Always wait a few seconds after making coffee as it will be held in place until it is safe to remove. 13 If you want to make further cups of coffee wait for the flashing OK indicator light to glow again continuously. Wait a few seconds then pull out the pod filter holder and fit a new coffee pod or change the pod filter if an alternative type of coffee is desired. Note: when making an espresso the coffee maker will make a pumping noise which will cease part way through the operation but will resume again before all the drink is dispensed. This ensures that the best coffee flavour is extracted. After each coffee is dispensed, excess water from the brewing process will be discharged into the drip tray. The wires in the cord are coloured as follows: Green and Yellow = Earth, Blue = Neutral, Brown = Live. The appliance must be protected by a 13A approved (BS1362) fuse. WARNING: THIS APPLIANCE MUST BE EARTHED. Note: For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service). If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet. This machine complies with European Economic Community Directive 89/336/EEC. key tank lid cup storage pod filter (3 supplied ) pod filter holder coffee outlet power on button/indicator light OK indicator light steam button/indicator light drip tray cover drip tray steam/hot water nozzle function lever water tank important When selecting the power on and steam buttons always press them firmly. 2 to produce steam to froth milk after having brewed coffee 1 Ensure that the pod filter holder with a pod holder is fitted to the coffee maker. 2 Press the steam button and its light will flash (see Fig. When the steam indicator light glows continuously the unit is ready to produce steam (see Fig. 3 Place an empty jug under the steam/hot water nozzle and move the function lever to the lower steam position ( ) to remove excess water from the system. Return the function lever to the middle ( ) position and discard the water. 4 Part fill a jug with milk ­ the milk may increase up to three times in volume so select a suitably sized jug. Fresh cold semi skimmed milk gives the best results. 5 Position the jug under the steam/hot water nozzle 6 Place the nozzle into the milk and move the function lever to the lower steam position ( ). The milk will begin to increase in volume and appear frothy . [. . . ] UK If you need help with: using your machine or servicing, spare parts or repairs (in or out of guarantee) call Kenwood customer care on 023 9239 2333. Have your model number ready ­ it's on the underside of the coffee maker. spares and attachments call 0870 2413653. other countries Contact the shop where you bought your machine. [. . . ]