User manual KENWOOD IH100,MV

[. . . ] Do not use the induction hob if the hob plate is broken or cracked in any way. Do not put hot or sharp implements or pans onto the control panel. Never put paper, aluminium foil, cloth, plastic materials or other unrelated objects on the hob plate when the induction hob is in use or is hot. Foil used to cover items during cooking should not be allowed to come in direct contact with the hob plate. [. . . ] Overheating should be avoided at all times. Persistent overheating can cause permanent damage to your cookware. Do not place credit cards, magnetic media or sensitive electronic equipment near to the appliance when in use. During operation, the induction hob should be placed horizontally, on a flat heat resistant surface, at least 10cm away from all sides of the wall. Do not let infirm people use the appliance without supervision. Do not let children use or play with the appliance. Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions. suitable cookware Only use flat bottomed pans that are suitable for induction hob use. If in doubt, check with the manufacturer of your pans. If they are unsuitable the induction hob will not detect the pan. The induction hob is suitable for pans with a base diameter of 12 ­ 22cm. The fan will continue to operate after the appliance has been switched off. timer mode 1 When the timer button is pressed it will light up, the appliance will beep, the LED display flashes and shows "00:00". Set the time using the "+" or "-" button, "+" will increase the time by 1 minute, "-" will decrease the time by 1 minute. To quickly set the time in 10 minute increments hold the "+" or "-" button down. This should be done within 5 seconds of pressing the timer button or the LED display will default back to ­­:­­. 2 Once the timer has been set the LED display will flash. Select the desired power level within 5 seconds (if not timing will not begin and the appliance will automatically turn off within 2 minutes). The display will then count down (indicated by the colon flashing) and heating will begin. 3 After the set time has been reached, the appliance will turn off. 4 To cancel timing during the count down, press the timer button. It will continue heating unless it is switched off. care & cleaning safety features Switch off, unplug and allow the appliance to cool down completely before cleaning. Never immerse the induction hob in water. Hob plate, body and control panel: Wipe with a soft damp cloth or non ­ abrasive cleaner and dry thoroughly. [. . . ] If the induction hob is in operation and no button is pressed it has an automatic switch-off in accordance with the times in the table below, (except for when timing program exceeds 2 hours). power level 1, 2 3, 4 5, 6 time 4 hours 3 hours 2 hours Once the pan is moved away the hob plate will stop heating. 5 service and customer care If the cord is damaged it must, for safety reasons, be replaced by Kenwood or an authorised Kenwood repairer. UK If you need help with: using your induction hob or servicing, spare parts or repairs (in or out of guarantee) call Kenwood customer care on 023 9239 2333. Have your model number ready ­ it's on the underside of the induction hob. [. . . ]