User manual KENWOOD JKM075

[. . . ] Take care when opening the lid droplets of hot water may be ejected. Make sure the kettle is switched off before lifting or pouring. Unplug the kettle before filling or pouring. Never put the kettle near or on cooker hot plates or gas burners. [. . . ] 4 Your kettle will boil and switch off automatically. To re-boil, wait a few seconds - the on/off switch needs time to reset. If you experience problems with your kettle switching on and off during use or switching off before boiling, check that the flat element is free from scale - see "descaling". Your kettle is fitted with a filter to hold back limescale particles. If you find drops of water under your kettle, don't worry - it is just condensation. the filter 1 Open the lid. 3 either rinse under the tap or use a soft brush. or when descaling your kettle, drop the filter in too. 4 Replace the filter by locating the front of the filter into the spout area and then clip into place . descaling Regular descaling of the flat element will improve the performance of your kettle. If the kettle is not descaled regularly the build up of limescale may result in the following: problems may be experienced with the kettle switching on and off during use or switching off before boiling. Please note: Failure to descale your kettle may invalidate your guarantee. When limescale starts to build up on the heating element, buy a suitable descaler and descale your kettle. After descaling, boil with fresh water several times and discard. Clean any descaler off the kettle - it can damage the parts. Some regions of the country have chalky water. This makes boiled water look cloudy and leaves a Note: For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service). If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet. This kettle complies with European Economic Community Directive 89/336/EEC. before using for the first time 1 Fill to `MAX', boil, then pour the water away. [. . . ] Mix well and test the temperature with your elbow before you put baby in. run cold water over a burn immediately, then get medical help. Don't stop to remove clothing. service and customer care If the cord is damaged it must, for safety reasons, be replaced by KENWOOD or an authorised KENWOOD repairer. UK If you need help with: using your kettle servicing or repairs (in or out of guarantee) call Kenwood Customer Care on 023 9239 2333. [. . . ]