User manual KENWOOD KDC-W5137

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. This Class B digital apparatus complies with Canadian ICES-003. Take the following precautions to prevent fire and avoid personal injury : · check that no metal objects (coins , tools , etc. [. . . ] Install the unit as far away as possible from the speakers. ⷠBe sure to use CDs with disc mark only for this unit. ⷠCD-Rs and CD-RWs which have not undergone finalization processing cannot be played. (For more information on finalization processing, refer to the manual for your CD-R/CD-RW writing software or CD-R/CD-RW recorder. ) Additionally, depending on the recording status, it may prove impossible to play certain CDs recorded on CD-R or CD-RW. Do not use the CD with the label sticker stuck on it. Using such a CD may cause the CD to be deformed and the sticker to peel off, resulting in malfunction of the unit. If you have difficulty in installing this unit in your vehicle, contact your Kenwood dealer. ⷠIf it doesn't seem to be working properly, first press the Reset button. If the front panel is dirty, wipe it clean with a silicon cloth or soft dry cloth with the power off. Do not use hard cloths or paint thinner, alcohol, or other volatile solvents. A CD-R or CD-RW is more susceptible than a music CD to damage from high temperatures and humidity, and in some cases, may become unusable if left in the car for long periods of time. ⷠIf you do not use your unit for an extended time, remove the discs from the unit and put them in their cases. Do not leave them lying around without cases, piled up, or leaning on a wall and so on. ⷠIf you attach an adapter to an 8 cm (3") compact disc and load it into this unit, the adapter may be detached from the disc, causing damage to the unit. Way up with the "disc" logo on the top. Insert the tray into the disc magazine until it locks. check that the discs and trays are inserted properly. The discs are numbered from the bottom from 1 to 6 or 10. 2CAUTION · Take care to insert trays into the correct grooves in the disc magazine and to insert discs properly into the tray grooves. Otherwise malfunction may occur or the disc may be damaged. ⷠInsert all trays even when some of them do not carry discs. [. . . ] If the switches are not set properly, sound skip or other malfunction may occur. ⷠSet the angle adjustment switches with a coin or other flat object. ⷠChange the switch step by step by detaching and reusing the obdect at the end of each step. 3 Use the holes marked to install the unit. [. . . ]