User manual KENWOOD KDV-MP4343

[. . . ] If your vehicle's ignition does not have an ACC position, or if the ignition wire is connected to a power source with constant voltage such as a battery wire, the power will not be linked with the ignition (i. , it will not turn on and off along with the ignition). If you want to link the unit's power with the ignition, connect the ignition wire to a power source that can be turned on and off with the ignition key. If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing and opening. [. . . ] If the fuse blows, first make sure the wires aren't touching to cause a short circuit, then replace the old fuse with one with the same rating. Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. The driver must not watch the monitor while driving. ­ This warning appears only when the parking brake lead is connected to the parking brake system built in the car. The heat sink becomes very hot after use. Be careful not to touch it when removing this unit. If any item is missing, consult your Kenwood Car Audio dealer immediately. View from the lead side Von der Kabelseite aus gesehen Power cannot be turned on. * Is the rear ground terminal connected to the car's chassis using shorter and thicker cords?The leads of the power cord and those of the connector from the car body may be different in color. Connect the colored leads of the power cord in the order specified in the illustration below. To the power control lead of other equipment or power aerial if any (200 mA max. Installation, this lead must be connected, otherwise power cannot be turned on. When installing the monitor in a location where it can be seen by the driver Connect the parking brake wire to the parking brake system built in the car. When installing the monitor in a location where it cannot be seen by the driver Connect the parking brake wire to metallic body or chassis of the car. You can connect amplifiers to upgrade your car stereo system. [. . . ] You can connect amplifiers to upgrade your car stereo system. Connect the power control lead (blue with white stripe) to the power control lead of the other equipment so that it can be controlled through this unit. Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused. [. . . ]