User manual KENWOOD KFC-XW12R

[. . . ] N Door panel • When the door window glass is lowered (opened), the unit is damaged. € When the window crank handle is rotated, it comes into contact with the unit. N Rear deck •  When the unit comes into contact with the boot lid spring (trunk lid spring) or shock absorbers (shock towers). [. . . ] € When the unit damages the gas tank or fuel hose. € When the unit comes into contact with the rear window glass, car wall, etc. For this reason specifications may be changed without notice. 7) Information on Disposal of Old Electrical and Electronic Equipment (applicable for EU countries that have adopted separate waste collection systems) Products with the symbol (crossed-out wheeled bin) cannot be disposed as household waste. Old electrical and electronic equipment should be recycled at a facility capable of handling these items and their waste byproducts. Contact your local authority for details in locating a recycle facility nearest to you. Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on our health and the environment. M g (oz) IMPORTANT SAFEGUARDS Caution : Read this page carefully to keep your safety.  ut off a large hole and make screw holes. Instalação n  assive crossover network / Réseau séparateur passif / Red divisora pasiva / P Rede de separação passiva / How to remove Comment retirer Cómo extraer Como remover n  oofer / Graves / Altavoz de graves / Altifalante de graves / W ø4 ø 4 x 25 For GM vehicles Pour véhicules GM Para vehículos GM Para veículos GM For HONDA and other manufacturer vehicles Pour véhicules HONDA et d’autres fabricants Para vehículos HONDA y de otros fabricantes Para veículos HONDA e outros fabricantes ø 4 x 25 ø4x6 ø4x6 ø 4 x 25 ø 4 × 25 Note: • Do not install in places under direct sunlight. €  o not touch the electronic parts inside the crossover network. 5 / Figura 5/ n  weeter / Aigus / Altavoz de agudos / Altifalante de agudos / T Flush mounting / Montage encastré / Montaje nivelado / Montagem plana / For removing and installing the Tweeter, see Fig. 4-7 / Figura 4-7 / System connections With this unit, the speaker cords are not supplied. Obtain the audio speaker cords with the required length. To connect the speaker cords to the unit, terminate the wires with female spade connectors. Note: When using the speaker as a Three-way speaker combined with a sub woofer connect nonpolar capacitors in series (with voltage resistance greater than 63V and capacitance less than 270μF) as H. [. . . ] To connect the speaker cords to the unit, terminate the wires with female spade connectors. Note: When using the speaker as a Three-way speaker combined with a sub woofer connect nonpolar capacitors in series (with voltage resistance greater than 63V and capacitance less than 270μF) as H. N Example / Example / Ejemplo / Exemplo / Tweeter attenuator switching / Réglage d’atténuateur du hautparleur d’aigus / Conmutación del atenuador del altavoz de agudos / Comutador do atenuador do altifalante de agudos / When changing the setting, change the jumper position as follows. [. . . ]