User manual KENWOOD KNA-DV2600

[. . . ] KNA-DV2600 DVD NAVIGATION SYSTEM INSTRUCTION MANUAL © B64-2784-00/00 (C) Contents Safety precautions Replacing Map Discs 3 4 Route Guidance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37 Initiate route guidance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37 When cancel or resume route guidance. . . . . . . . . . . 37 Open road route guidance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When only one destination has been set, the screen 3 will appear. Select when you wish to clear all the destinations. Select . If only one destination has been set when all the destinations are cleared, the screen indicating the current point will appear. Select . Route searches will be conducted again. · There is no way to restore deleted destinations. Operations should be carefully performed in order not to make mistakes. · If you clear all the destinations, route navigation will become impossible. It is necessary to set the destinations and conduct route searches again. · The screen for step 3 will also appear by selecting on the MENU screen for setting destinations. 32 | English Setting passing roads It is possible to set a maximum of 2 passing roads (passing points) on the route. 1 2 3 4 5 6 7 8 Select on the MENU screen or the Whole Route screen. Select of passing points (designation of passing roads) on the screen for changing routes. Scroll the map to the position for designating passing roads. Select . Select to select passing roads. When designating the displayed roads, select . Select . The passing roads will be designated with marks . Select of the road section to be designated. Select . Route searches will be conducted again. · When the maps shown in step 6 have little information, no roads may be selected even if is selected. · When the set destination is only one and no roads to pass through are set, operations for step 7 is not necessary. English | 33 Setting routes and route navigation When correcting the passing roads 1 2 3 4 5 6 7 Select on the MENU screen or the Whole Route screen. Select of passing points (designation of passing roads) on the screen for changing routes. When only one point has been set, the screen 3 will appear. Select a button of passing points to correct. The map will appear. Scroll the map to the position for designating passing roads. Select . Select to select passing roads. When designating the displayed roads, select Select . The passing roads will be designated with marks. . 34 | English 8 Select . Route searches will be conducted again. · When the maps shown in step 6 have little information, no roads may be selected even if is selected. When canceling designation of passing roads 1 2 3 4 5 Select on the MENU screen or the Whole Route screen. [. . . ] See page 6 of this manual to display the Current Position screen. The GPS antenna or your vehicle might be in a position where GPS signals cannot be received. Try moving the GPS antenna or your vehicle to a position where there are no obstacles around. The GPS marker is not displayed on the road where your vehicle is running. [. . . ]