User manual KENWOOD KNA-G520

[. . . ] If any such object is accidentally swallowed, consult a doctor immediately. Caution Failure to avoid the following potentially hazardous situations may result in injury or property damage. · Make sure to ground the unit to the chassis of your vehicle. · Secure all wiring with cable clamps or electrical tape. [. . . ] Insulate unconnected wires; do not allow any bare wiring to remain exposed. · Do not let unconnected wires or terminals touch metal on the vehicle or anything else that can conduct electricity. · Do not open the top or bottom covers of the unit. · The KNA-G520 is not waterproof. February 2006 Part Number 190-00493-50 Rev. A Printed in Taiwan English What's Included GPS antenna main unit screws (4) wiring harness hook and loop fasteners (2) Use the screws or the hook and loop fasteners (similar to Velcro®) provided to mount the main unit in the vehicle. Select a location that allows you to access the unit's SD card slot. Be sure to place the unit horizontally (flat) and secure it completely for best performance. Installing the main unit Caution · Do not install the unit where it will be exposed to direct sunlight, excessive heat or humidity, dust, spills, or liquids. If you use the wrong screws, you could damage the unit. · Check for cables or other parts underneath the floor mat before cutting the floor mat. Installing the GPS antenna Caution · Do not paint the antenna. Set to High (most common) if a positive, high voltage is detected when the reverse lights are illuminated. Set to Low if no voltage or low voltage is detected when the reverse lights are illuminated. -2- English Optional accessory: FM traffic receiver SD card GPS antenna Installing the GPS antenna Best (roof of vehicle) Better (trunk of vehicle) Good (inside car on dashboard) Steps to Install the KNA-G520 1. Remove the key from the vehicle's ignition and disconnect the negative battery cable. Connect the wiring harness to your vehicle in the following order: ground, battery, ignition. Connect the wiring harness to the main unit. Reconnect the negative battery cable. To reverse lamp harness Purple, white stripe To display unit (NAV I/F terminal) WARNING Be sure to connect the parking brake wire to ensure safe navigation. Light green To parking brake detection switch Pink To car speed signal harness WARNING Do not cut off the protection diode on the speed signal detection wire. Doing so can cause damage to the vehicle. Black To vehicle chassis Car fuse box (main fuse) 2A CAUTION If your vehicle's ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, as with battery wires, the vehicle's battery may die. Red To ignition (12 V) Car fuse box 2A Ignition key switch WARNING Yellow To battery (12 V) Do not connect the yellow wire lead directly to the vehicle battery. Connecting directly to the battery may cause the wire insulation to fail and may pose a risk of short circuit and electric shock. -3- English Acquiring GPS Signals The first time you turn on the KNA-G520, you must wait while the system acquires satellite signals for the first time. [. . . ] Connecting directly to the battery may cause the wire insulation to fail and may pose a risk of short circuit and electric shock. -3- English Acquiring GPS Signals The first time you turn on the KNA-G520, you must wait while the system acquires satellite signals for the first time. This process could take up to several minutes. Make sure your vehicle is outdoors in an open area away from tall buildings and trees for fastest acquisition. [. . . ]