User manual KENWOOD KRC-160

[. . . ] · If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your Kenwood dealer. · Be careful not to drop the unit or subject it to strong shock. The unit may break or crack because it contains glass parts. · Do not touch the liquid crystal fluid if the LCD is damaged or broken due to shock. [. . . ] Turning Attenuator On/Off: Press the ATT button to switch the attenuator on and off. When the attenuator is on, the ATT indicator blinks. When the attenuator is off, the volume returns to the original level. NOTE 3 Adjust each mode Press the 4/¢ button. Please refer to the following for the adjusting values. Turning the volume up, or turning it all the way down deactivates the attenuator function. 4 Press the AUD button to end the control mode. Loudness This function amplifies low and high tones when the volume is turned down. The LOUD indicator lights up when the loudness function is on. Turning Loudness On/Off: Press the LOUD button for at least one second to switch the loudness on and off. "BAS": Adjust the bass level. Setting values: - 8 - 8 "TRE": Adjust the treble level. Setting values: - 8 - 8 Audio Control Setting Adjust various parameters of sound quality. "BL": Adjust the balance level. Setting values: Left 15 - Right 15 --5-- General features English "FD": Adjust the fader level. Setting values: Rear 15 - Front 15 Adjusting Time Adjust the time. 1 When the time is not displayed, first press the CLK button to display the time. dB (Sound Coordinate) You can recall the best audio setting preset for different types of the music. 2 Press the CLK button for at least two seconds to enter the clock adjustment mode. The time display will blink. 3 · Adjusting the hours Press the BAND button to advance the hours. The tuner then plays the last station received. Recalling a Preset Station: Press the preset station button (#1-6) for the desired station. The number of the recalled station is displayed. Strong electrical fields (such as from power lines) may cause unstable sound quality when CRSC is turned on. In such a situation, turn it off. --8-- Cassette player features Playing Cassette Tapes Loading and Playing Cassettes: Load a cassette with the tape exposed on the right. With side A facing up, the 3 indicator lights up when side A is playing, and 2 when side B is playing. The 2 3 indicator lights up while play is paused. Playing Cassettes Already Loaded: Press the SRC (source) button repeatedly to select the tape mode. "TAPE" is displayed when the tape mode has been selected. Listening to the other side: Press the FF button and REW button at the same time. Stopping and Ejecting Cassettes: Press the 0 button. The tape stops playing and the cassette ejects. NOTE KRC-160 Remove a cassette from the unit when not listening to it for a while. [. . . ] 14)" and then remove the hard rubber frame. 2 Align the holes in the unit (two locations on each side) with the vehicle mounting bracket and secure the unit with the accessory screws. T N Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. 8mm MAX. T T/N ø5mm 3 ø5mm 4 T: Toyota cars N: Nissan cars 2CAUTION Self-tapping screw (commercially available) Metal mounting strap (commercially available) Accessory3. . . for Nissan car Accessory4 . . . for Toyota car NOTE Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip). · During installation, do not use any screws except for those provided. The use of different screws might result in damage to the main unit. [. . . ]