User manual KENWOOD KRC-21SG

[. . . ] To prevent injury and/or fire, take the following precautions: Insert the unit all the way until it is fully locked in place. Otherwise it may fly out of place during collisions and other jolts. When extending the ignition, battery, or ground wires, make sure to use automotivegrade wires or other wires with a 0. To prevent short circuits, never put or leave any metallic objects (e. [. . . ] Select the frequency to put in the memory Press the [4] or [¢] button. Put the frequency in the memory Press the [#1] -- [#6] button for at least 2 seconds. the preset number display blinks 1 time. On each band, 1 station can be put in the memory on each [#1] -- [#6] button. Temporarily have reception switched from stereo to mono to reduce multi-path noise when listening to the FM station. press the [CRSC] button for at least 1 second. Each time the button is pressed CRSC turns ON or OFF. Putting stations with good reception in the memory automatically. When 6 stations that can be received are put in the memory Auto Memory Entry closes. Each time the button is pressed the Tuner Call turns ON or OFF. The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the accessories shipped with the unit, as shown above. To prevent short circuits, remove the key from the ignition and disconnect the - terminal of the battery. Make the proper input and output wire connections for each unit. Take Connector B on the wiring harness and connect it to the speaker connector in your vehicle. Take Connector A on the wiring harness and connect it to the external power connector on your vehicle. If your car is not prepared for this special connection-system, consult your Kenwood dealer. Only use antenna conversion adapters (ISO-JASO) when the antenna cord has an ISO plug. Make sure that all wire connections are securely made by inserting jacks until they lock completely. If your vehicle's ignition does not have an ACC position, or if the ignition wire is connected to a power source with constant voltage such as a battery wire, the power will not be linked with the ignition (i. , it will not turn on and off along with the ignition). If you want to link the unit's power with the ignition, connect the ignition wire to a power source that can be turned on and off with the ignition key. [. . . ] The frame can be removed from the top side in the same manner. Pull the unit all the way out with your hands, being careful not to drop it. What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. [. . . ]