User manual KENWOOD KRC-3005

[. . . ] Otherwise it may fall out of place when jolted. · When extending the ignition, battery, or ground wires, make sure to use automotivegrade wires or other wires with a 0. 75mm2 (AWG18) or more to prevent wire deterioration and damage to the wire coating. · To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit. · If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your Kenwood dealer. [. . . ] Each time the button is pressed the Tuning mode switches as shown below. Tuning mode Display Operation Auto seek "AUTO" Automatic search for a station. indicator Manual -- Normal manual tuning control. #1 - 6 AM Tuning Selecting the station. 1 STEREO indicator Frequency display Preset station number Select tuner source Press the [SRC] button. Select the band Press the [FM] or [AM] button. Each time the [FM] button is pressed it switches between the FM1, FM2, and FM3 bands. Tune up or down the band Press the [4] or [¢] button. During reception of stereo stations the "STEREO" indicator is ON. 2 3 AUTO indicator (CRSC)indicator Band display --8-- Station Preset Memory Putting the station in the memory. 2 Call up the station Press the [#1] -- [#6] button. 1 2 3 Select the band Press the [FM] or [AM] button. Select the frequency to put in the memory Press the [4] or [¢] button. Put the frequency in the memory Press the [#1] -- [#6] button for at least 2 seconds. The preset number display blinks 1 time. On each band, 1 station can be put in the memory on each [#1] -- [#6] button. CRSC (Clean Reception System Circuit) Temporarily have reception switched from stereo to mono to reduce multi-path noise when listening to the FM station. Press the [CRSC] button for at least 1 second. Connect the wiring harness connector to the unit. Press the reset button. · If your car's ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, as with battery wires, the battery may die. · If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing and opening. · If the fuse blows, first make sure the wires aren't touching to cause a short circuit, then replace the old fuse with one with the same rating. · Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. · Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the - wires or ground them to any metal part in the car. · When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the + connector of the left speaker to a front output terminal, do not connect the - connector to a rear output terminal · After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. [. . . ] O-N switch is set to "O" side. Random play or magazine random play has been selected. Turn off random play or magazine random play. Track repeat, disc repeat, track scan, random play, and magazine random play start by themselves. [. . . ]