User manual KENWOOD KRF-V6010

[. . . ] AUDIO VIDEO SURROUND RECEIVER KRF-V7010 KRF-V6010 KRF-V5010 INSTRUCTION MANUAL KENWOOD CORPORATION This instruction manual is for some models. Model availability and features (functions) may differ depending on the country and sales area. About the supplied remote control (RC-R0507) . . Compared to standard remote controls, the remote control supplied with this receiver has several operation modes. These modes enable the remote control to control other audio/video components. [. . . ] Use this setting when listening with headphones for stereo sound in all playback modes. A ON · Activating a surround mode or selecting "DVD 6ch" as the input source causes speaker system A to be selected automatically. On the KRF-V5010, press the SPEAKERS key to switch the speakers on and off. The indicator for the speakers you want to use should be lit. SP A L R Indication in feet 1)FT 3. )M Indication in meters · The allowable setting range is 1 to 30 feet (0. 3 to 9. 0 m), adjustable in 1 foot (0. 3 m) increments. 4 Repeat steps 2 and 3 to input the distance for the surround speaker. 5 Setup is complete when the input indication reappears. L R SW Display when all speakers have been selected. · The speakers you selected appear on the display. Confirm that all the speakers have been correctly selected. · If you used the remote control (RC-R0507) to perform the settings, press the VIDEO key at this point to turn off the remote control's own adjustment mode. In this case, the input source is not switched. CD Speaker indicator lights. SP AB L R SW L R SW Models other than KRF-V5010 KRF-V5010 Selecting VIDEO 2/MONITOR Depending on the component connected to the VIDEO 2/MONITOR jacks, select either the "VIDEO 2" setting or the "MONITOR" setting, as appropriate. 8 Normal playback KRF-V7010/V6010/V5010 (En/T) Listening to a source component VOLUME CONTROL INPUT SELECTOR Adjusting the sound SOURCE DIRECT VOLUME CONTROL BASS BOOST SOUND 15 AUDIO VIDEO PHONES MULTI CONTROL SPEAKERS A/B SPEAKERS, MUTE (KRF-V5010) VIDEO BASS BOOST VOLUME VOLUME VOLUME TUNING/SKIP MUTE SOUND RC-R0307 MUTE VOLUME SOUND MULTI CONTROL RC-R0507 RC-R0307 RC-R0507 1 Use the input selector (INPUT SELECTOR (AUDIO, VIDEO)) to select the source you want to listen to. The input sources change as shown below: Selecting a source using the INPUT SELECTOR knob 1 2 3 4 5 6 7 TUNER "CD" ("CD"*) "TAPE" or "MD" ("TAPE"*) "PHONO"("PHONO"*) "VIDEO1" ("VCR1"*) "VIDEO2" ("VCR2"*) "DVD 6ch" The following adjustments are possible if the receiver is in the stereo mode. 1 Press the SOUND key to select the tone mode to be adjusted. BASS: Select this to adjust the low frequency range. (Press the SOUND key once. ) TREB: Select this to adjust the high frequency range. (Press the SOUND key twice. ) SP Selecting a source using the AUDIO key on the remote control (RC-R0507) 1 2 3 4 "CD" ("CD"*) "TAPE" or "MD" ("TAPE"*) TUNER "PHONO"("PHONO"*) A L R SW TREB +4 AUTO MEMO. STEREO ST. TUNED 2 Use the MULTI CONTROL (TUNING/SKIP) to adjust the sound quality. · The bass and treble levels are adjustable from -10 to +10 in 2 step increments. · The adjustment item is displayed for approximately eight seconds. · If you used the remote control (RC-R0507) to perform the above setting, press the VIDEO key at this point to turn off the remote control's own adjustment mode. In this case, the input source is not switched. Selecting a source using the VIDEO key on the remote control (RC-R0507) 1 "VIDEO1" ("VCR1"*) 2 "VIDEO2" ("VCR2"*) 3 "DVD 6ch" 4 "<--->" (Not used by this receiver. ) · When selecting an input source by using the remote control (RCR0307), press the desired input selector key. · "VIDEO 2" can be selected as an input source only if the VIDEO 2/MONITOR setting is "VIDEO 2". 8 * Once setup codes are registered in the remote control (RCR0507), the input name display changes according to the name of the registered component. [. . . ] 0. 8% (65. 2 dBf input) Signal to noise ratio (DIN weighted, 1 kHz) U. K. and Europe MONO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65 dB (40 kHz DEV. , 65. 2 dBf input) STEREO . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60 dB (46 kHz DEV. , 65. 2 dBf input) Russia MONO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]