User manual KENWOOD KRF-V6070D

[. . . ] Compared to standard remote controls, the remote control supplied with this receiver has several operation modes. These modes enable the remote control to control other audio/video components. In order to effectively use the remote control it is important to read the operating instructions and obtain a proper understanding of the remote control and how to switch its operation modes (etc. Using the remote control without completely understanding its design and how to switch the operation modes may result in incorrect operations. [. . . ] 1 For the remote control, press and hold the TUNER key for more than 3 seconds to switch to receiver mode. You can enjoy a more impressive sound effect when ACTIVE EQ is turned ON during Dolby Digital and DTS playback and, when in PCM and analog stereo mode. Press the ACTIVE EQ key for the following selections; 1 ACTIVE EQ MUSIC : Effective when listening to music. ACTIVE EQ function will not be available when REC MODE, AUTO TUNING or PRESET MEMORY is ON and during 96kHz LPCM playback. 4 When in TONE ON selection, press the Tone key for the following displays. BASS : Select this to adjust the low frequency range. tREB : Select this to adjust the high frequency range. 5 Use the MULTI CONTROL knob or Multi %/fi keys to adjust the sound quality. The bass and treble levels are adjustable from -10 to +10 in 2 step increments. 1 Press the SPEAKERS ON/OFF key so that the speaker indicator goes off. Make sure the SP indicator is turned OFF. You can adjust the sound quality when the receiver is in the PCM stereo and analog stereo modes. Press the key once to select the maximum (+10) low frequency emphasis setting. This key does not function when the receiver is in the sound quality or ambience effects adjustment mode. If you turn off all of the speakers when in surround mode, the surround mode will be canceled as well, resulting in stereo playback. 3 Press and hold the DIMMER key for more than 2 seconds to select the A-REC or M-REC mode during digital input. 1 Rec mode off : The digital input record mode is switched off. 2 A-REC mode : The digital input signals (DTS, Dolby Digital, or PCM) are identified automatically and converted into stereo signals that are ready for recording. 3 M-REC mode : The input signal type at the moment this mode is selected is held throughout this mode. 1 Use the INPUT SELECTOR knob to select the source (other than "MD/TAPE") you want to record. 1 Use the INPUT SELECTOR knob to select the video source (other than "VIDEO1") you want to record. Recording may not be normal for some video software. [. . . ] There are many possible causes for this problem, depending on the type of DVD player used. Noise due to interference from an electric appliance. A station which was preset cannot be received by pressing the corresponding numeric key. The preset station belongs to a frequency that cannot be received. [. . . ]