User manual KENWOOD KRF-V8080D

[. . . ] ENGLISH AUDIO VIDEO SURROUND RECEIVER KRF-V8080D INSTRUCTION MANUAL KENWOOD CORPORATION About the supplied remote control Compared to standard remote controls, the remote control supplied with this model has several operation modes. These modes enable the remote control to control other audio/video components. In order to effectively use the remote control it is important to read the operating instructions and obtain a proper understanding of the remote control and how to switch its operation modes (etc. ). Using the remote control without completely understanding its design and how to switch the operation modes may result in incorrect operations. FRANÇAIS DEUTSCH NEDERLANDS ITALIANO ESPAÑOL B60-5460-00 00 MA (E) 0401 *5460/01-09/EN 1 04. 3. 5, 9:03 AM Before applying the power Units are designed for operation as follows. [. . . ] : The digital input record mode is switched off. 2 REC MODE AUTO : The digital input signals (DTS, Dolby Digital, or PCM) are identified automatically and converted into stereo signals that are ready for recording. 3 REC MODE MANUAL : The input signal type at the moment this mode is selected is held throughout this mode. • When the REC MODE MANUAL is selected, the digital input signal is converted to stereo signals (down-mix). But once the digital signal is changed to other signal, no signal is output. When the REC MODE AUTO is selected, the digital input signal is converted to stereo signals even if the digital signal is changed. For REC MODE AUTO : SP L MUTE CLIP DTS. DOLBY DIGITAL STEREO OPTICAL 6CH INPUT AUTO DETECT CINEMA EQ. MATRIX DSP MODE DISCRETE PRO LOGIC LOUDNESS ANALOG 96kHzfs NEO:6 CSII THX Surround EX RDS RTY AUTO MEMO STEREO TUNED 1 REC MODE off ENGLISH MD/TAPE Recording a music source 1 Use the Input Selector keys to select the source (other than “MD/ TAPE”) you want to record. 2 Set the MD or TAPE recorder to record. 3 Start playback, then start recording. Recording video 1 Use the Input selector keys to select the video source (other than “VIDEO 1”) you want to record. 2 Set the video deck connected to VIDEO 1 to record. • Select the REC MODE to record a digital input source. • Recording may not be normal for some video software. This is due to the copy guard condition. t C LFE R A B COAXIAL SL S SB SR SP L C LFE R A B MUTE CLIP COAXIAL DTS. DOLBY DIGITAL STEREO OPTICAL 6CH INPUT AUTO DETECT CINEMA EQ. MATRIX DSP MODE DISCRETE PRO LOGIC LOUDNESS ANALOG 96kHzfs NEO:6 CSII THX Surround EX RDS RTY AUTO MEMO STEREO TUNED SL S SB SR For REC MODE MANUAL : Recording audio (digital sources) Switch on the REC MODE to record a digital input source. Usually use the REC MODE AUTO to record audio input sources. When the digital mode changes during recording in the REC MODE AUTO, the audio input source may be interrupted momentarily. SP L C LFE R A B MUTE CLIP COAXIAL DTS. DOLBY DIGITAL STEREO OPTICAL 6CH INPUT AUTO DETECT CINEMA EQ. MATRIX DSP MODE DISCRETE PRO LOGIC LOUDNESS ANALOG 96kHzfs NEO:6 CSII THX Surround EX RDS RTY AUTO MEMO STEREO TUNED SL S SB SR Recording music in REC MODE AUTO or MANUAL DIMMER SP L C LFE R A B MUTE CLIP COAXIAL DTS. [. . . ] 1 Vp-p / 75 Ω COMPONENT VIDEO (CB/CR-signal) . . . . . . . . . . . . . ±0. 32 Vp-p / 75 Ω ENGLISH FM tuner section Tuning frequency range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87. 5 MHz ~ 108. 0 MHz Usable sensitivity MONO . . . . . . . . . . . . . . . . . . 1. 3 µV (75 Ω)/ 13. 2 dBf (40 kHz dev, S/N 26 dB) STEREO . . . . . . . . . . . [. . . ]