User manual KENWOOD KRF-V8300D

[. . . ] Using the remote control without completely understanding its design and how to switch the operation modes may result in incorrect operations. ESPAÑOL B60-5339-00 00 ID (E) 0211 1 EN Before applying the power Units are designed for operation as follows. and Canada . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 120 V only Australia . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Distance to front speakers : ____ feet (meters) Distance to center speaker : ____ feet (meters) Distance to surround speakers : ____ feet (meters) 3 Use the MULTI CONTROL knob or keys to select the distance to the front speakers. The speaker indicator to be adjusted blinks. ENGLISH !Press the SETUP key again to accept the setting. · The subwoofer re-mix setting indication "SW RE-MIX" scrolls across the display. · If subwoofer is turned OFF, subwoofer re-mix setting is not visible. @ Use the MULTI CONTROL knob or keys to select the appropriate subwoofer re-mix setting. 1 RMX ON : Subwoofer re-mix set mode to the receiver is ON. 2 RMX OFF : Subwoofer re-mix set mode to the receiver is OFF. # Press the SETUP key to accept the setting. · The receiver enters the speaker volume level adjustment mode. · In step 4 and 5, indications appear only for the selected channels of the speakers that require adjusting. Indication in feet Indication in meters · The allowable setting range is 1 to 30 feet (0. 3m to 9. 0m), adjustable in 1 foot (0. 3m) increments. 4 Press the SETUP key to accept the settings. 2 Hold down the AUTO key for more than 2 seconds. · The source indication changes to "MD". · To return to the original indication, repeat procedure 2. Setting the speaker status The speaker indicator lights up. 2 Start playback from the selected source. 3Use the VOLUME CONTROL knob or VOLUME keys to adjust the volume. Press the SPEAKERS ON/OFF key to switch the speaker on or off. 19 EN Normal playback Adjusting the sound Adjusting the LOUDNESS mode (remote control only) SPEAKERS ON/OFF ACTIVE EQ VOLUME CONTROL You can adjust the Loudness function which controls the low volume settings to maintain the music's richness. The adjustment can be made when the receiver is in the PCM stereo and analog stereo mode. Press the LOUDNESS key to turn the LOUDNESS setting ON. ENGLISH To cancel Press the LOUDNESS key again so that the "LOUDNESS" indicator goes off. PHONES MULTI CONTROL MUTE Muting the sound The MUTE key lets you mute the sound of the speakers. Press the MUTE key. BASS BOOST MUTE LOUDNESS MULTI CONTROL ACTIVE EQ TONE VOLUME To cancel Press the MUTE key again so that the "MUTE" indicator goes off. · MUTE ON can also be deactivated by turning the volume control knob. Adjusting the TONE (remote control only) You can adjust the sound quality when the receiver is in the PCM stereo and analog stereo mode. 1 Press the TONE key to select the TONE mode. 2 Use the MULTI CONTROL knob or keys to select TONE ON/OFF. ACTIVE EQ mode You can enjoy a more impressive sound effect when ACTIVE EQ is turned ON during Dolby Digital and DTS playback and, when in PCM and analog stereo mode Press the ACTIVE EQ key for the following selections; 1 ACTIVE EQ MUSIC : Effective when listening to music. (The ACTIVE EQ LED indicator lights up. ) 2 ACTIVE EQ CINEMA : Effective when watching a movie. [. . . ] (30 Hz ~ 15 kHz), +0. 5 dB, ­3. 0 dB AM tuner section Tuning frequency range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 531 kHz ~ 1, 602 kHz Usable sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 µV / (600 µV/m) Signal to noise ratio (30% mod. 50 dB AUDIO section (KRF-V8300D) Rated power output during STEREO operation (DIN 1 kHz 0. 7% T. H. D. , at 6) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]