User manual KENWOOD KS-308HT

[. . . ] Caution: Read this item carefully to keep your safety. Suffocation ­ After taking the unit out of the polyethylene bag, be sure to dispose of the polyethylene bag out of the reach of children. Otherwise, they may play with the bag, which could cause hazard of suffocation. Water and moisture ­ The appliance should not be used near water - for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. [. . . ] Heat ­ Do not install the unit near a source of heat, such as radiators, or under direct sunlight. Modification ­ Do not attempt to open or modify the unit, for this could cause fire hazard or malfunction. Cleaning ­ Do not use volatile solvents such as alcohol, paint thinner, gasoline, or benzine, etc. Abnormal smell ­ If an abnormal smell or smoke is detected, immediately turn the power OFF and unplug the appliance from the wall outlet. This speaker system can provide full Surround sound. To enjoy the full effect of the Surround sound field, please position the speakers as described below. Place the left and right speakers at each side of your TV. Angle the speakers towards the listening area to enhance the stereo effect. Place the center speaker on the center between the front left and right speakers. Please observe the following precautions when mounting speakers onto the wall or speaker stand. Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. Wall screws must be purchased separately. Be sure to use screws that are appropriate for the wall or stand you are using, and that are long enough to provide sufficient strength. If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this type of installation, please consult a contractor or other qualified person before proceeding. Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient support strength. The speaker wires and labels of speakers' back panel are color-coded to facilitate connection. connect each wire to the matchingcolored terminal , as shown in the figure. [. . . ] connect each wire to the matchingcolored terminal , as shown in the figure. Be sure to turn off your amplifier before connecting or disconnecting speakers. To avoid speaker damage, never run the speakers at power levels exceeding this limit. To ensure safe and reliable operation, be sure that your amplifier or receiver is able to work with 8-ohm speakers. [. . . ]