User manual KENWOOD KS-8200HT

[. . . ] Heat ­ Do not install the unit near a source of heat, such as radiators, or under direct sunlight. Modification ­ Do not attempt to open or modify the unit, for this could cause fire hazard or malfunction. Cleaning ­ Do not use volatile solvents such as alcohol, paint thinner, gasoline, or benzine, etc. Abnormal smell ­ If an abnormal smell or smoke is detected, immediately turn the power OFF and unplug the appliance from the wall outlet. [. . . ] (This allows the TV's degaussing circuitry to correct for the magnetic field from the speakers. ) If distortion is still present, move the speakers further from the TV. The supplied speaker stands can be used to install either the front or surround speakers. The round encircled numerals in the following text refer to the items listed on the "Included parts list" page. The supplied speaker wires are color-coded according to the speakers to be connected. Using the supplied speaker stands with the front speakers Remove the two screws from the rear of each speaker. remove the cap and dressing sheet from the pole assembly 1. Attach holder A 2 and holder B 3 to both sides of the pole assembly 1 as if sandwiching it, and insert the screws removed from the speaker into the holes on the holders through them and the pole as shown in the figure. Make sure you attach the holders correctly in the correct orientations. Distribute the provided speaker wire through the hole on the holders and the hole on the bottom plate of the pole assembly 1 , and connect the speaker wire to the terminal on the speaker. Be sure to observe the polarity of the wire's conductors and terminals when connecting. Using the screws removed in step 2, attach only the plate (small) to holder A 2. Remove the two screws from above and below the terminal on the rear of the speaker. Distribute the speaker wire through the hole on holder A 2 and then connect it to the terminal on the speaker. Using the screws removed from the speaker, attach holder A 2, together with the plate (small), to the speaker. attach cushions 7 to the plate (small). The cushions prevent the speaker from sliding, and dampen its vibrations. The cushions prevent the speaker from sliding, and dampen its vibrations. You can hang the front and surround speakers on the wall vertically, and the center speaker horizontally. To install the front speakers and center speaker on the wall, it is first required to attach the supplied brackets on the rear of the speaker. Remove the two screws from each speaker and, using the removed screws, attach two brackets to the rear of the speaker. Check the top and bottom of each bracket and attach it correctly as shown. [. . . ] If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this type of installation, please consult a contractor or other qualified person before proceeding. Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient support strength. The speaker can be installed on the SR-8000 stand optionally available from KENWOOD. [. . . ]