User manual KENWOOD LZ-651W

[. . . ] If the liquid crystal fluid from the LCD contacts your body or clothing, wash it off with soap immediately. This video unit is set for rear passenger use only. Use of this video unit in any front seat and/or where it may be visible to the driver may be illegal in some states and may cause driver distraction and accident which could injure or kill you. 2CAUTION To prevent damage to the machine, take the following precautions: · Make sure to ground the unit to a negative 12V DC power supply. · Do not open the covers of the unit. [. . . ] Also, the monitor exits from Menu mode by no opeation for 10 seconds. VOICE 4 English Setup MENU 1 2 Press MENU button. ENTER Select "SETUP", and press VOICE button. 3 Press or button to select the adjusting item. "NAV": Setup input and switch method of the navigation picture. Item "RGB"* "AV-IN" "OFF" Setting When Kenwood navigation system is connected by the dedicated cable. When connected to AV-IN terminal be composite signal cable. It doesn't switch the navigation picture. *Default setting If you set to "OFF" while the audio source is set to "NAV", the audio source would switch to "NORMAL". "AV-IN": Setup switch method of the picture input to AVIN terminal. Item "VD"* "CAM" "OFF" Setting Switched by the operation of the video source. Switched automatically when video signal is input to AV-IN terminal. It doesn't switch the picture input to AV-IN terminal. *Default setting You cannot set "AV-IN" when "NAV" is set to "AV-IN". If you set to "OFF" while the audio source is set to "AV-IN", the audio source would switch to "NORMAL". "BEEP": Setup the beep sound ON/OFF. Item "ON" "OFF"* Setting Beep is heard. Beep is canceled. *Default setting 4 5 Press or button to select each item. ENTER Select "RETURN" and press to end the Menu mode. Also, the monitor exits from Menu mode by no opeation for 10 seconds. VOICE English 5 Installation English Accessories A B C D (Ø4 x 12 mm) E The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the accessories shipped with the unit, as shown above. Installation Procedure 1. To prevent short circuits, remove the key from the ignition and disconnect the · terminal of the battery. Make the proper input and output cable connections for each unit. Connect the wiring harness cables in the following order: ground, ignition. Connect the wiring harness connector to the unit. Reconnect the - terminal of the battery. 2WARNING the installation bracket. · If you are not going to install the unit using the supplied monitor stand, be sure to use a commercially available monitor stand. (Mounting holes for such a stand are located on the bottom of the monitor unit. ) 2CAUTION · This product is intended for use with 12V DC negative ground power only. Do not connect it to any other power supply · To prevent shorting, disconnect the battery cable from the negative terminal of the battery during installation. · Be sure to firmly stabilise this product. Do not install it in a location which is not stable. · Follow the installation and wiring procedures described in this manual. Improper wiring or modified installation can not only result in malfunction or damage to the unit but may also result in an accident. [. . . ] Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. [. . . ]