User manual KENWOOD R-SG7

[. . . ] FM/AM RECEIVER R-SG7 DP-SG7 X-SG7 CD PLAYER CASSETTE TAPE DECK INSTRUCTION MANUAL KENWOOD CORPORATION COMPACT DIGITAL AUDIO TEXT B60-4358-00 EN 2 Before applying power Before applying power Caution : Read this page carefully to ensure safe operation. R-SG7/DP-SG7/X-SG7 (EN) Units are designed for operation as follows. U. S. A. and Canada . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 120 V only Australia . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When the key for the tens digit has been pressed erroneously at the time of input, press the +10 key several times to return to the original display and then enter the number again. Lights during stereo reception Frequency display AUTO ST. TUNED R-SG7 FM 8 9 . ) ) About display change during tuner reception (remote control only) The display will change each time the DISPLAY key is pressed. DISPLAY Knowledge sections MHz The "TUNED" indicator lights when a station is received. 2 Tune in a station. Auto tuning : Each press receives the next station. Manual tuning : Press and hold until the desired station is received. 1Reception band/Frequency 2Preset number/Frequency 3Clock 28 Recording Note Recording R-SG7/DP-SG7/X-SG7 (EN) Recording Note that this cassette deck cannot record onto Metal tapes. 4 Preparation section 3 3 1 5 2 Basic section 0 1. Load a tape in deck. Top side 1 1 Open the tray of the cassette deck. 3 Close the tray. Note ÷ Differentiation between normal (TYPE I) and high (TYPE II) tape is set automatically. ÷ Remove tape slack before loading. Application section Reverse side Since longer tape than 100 minutes cassette tape is very thin, the tape could adhere to the pinch roller or be easily cut. It is recommended that these tapes not be used with this unit to prevent possible damage. Check the tape transport direction indicator. 2. Select the tape transport direction. To reverse the transport direction 1 Press the playback key for the direction to be played (lights green). 2 Stop playback (lights red). ÷ When recording is started, the tape is transported in the direction selected in this step. ÷ Wind the tape to the position where recording is to be started. 2 3 Knowledge sections Dolby NR rev. Set the recording condition. 3 3 1 Select the reverse mode. 2 Select the DOLBY NR mode. £ £ Recording 29 R-SG7/DP-SG7/X-SG7 (EN) Temporary stop during recording 8 8 An unrecorded section of about 4 sec is produced (auto recording mute) 1 Obtain stop condition. 2 Press the record key twice. About 4 sec 8 ¶ ÷ Press the record key to restart recording. ¶ ¶ ¶ To interrupt recording An unrecorded section of about 4 sec is produced directly after the recording has been interrupted. 8 ¶ Preparation section ÷ An unrecorded section of about 4 sec is produced and recording pause condition is reached. ¶ ¶ To end recording 7 ÷ Recording pause condition is reached after approximately 4 sec. Basic section 4. Select the source to be recorded. input selector The input source component to be recorded should be displayed. R-SG7 4 Select an input source other than "TAPE" input. CD ÷ When the CD input is selected and if a disc has been set in the CD player, its playback starts immediately. Application section 5. Start recording. ¶ 5 1 Play (or tune) the input source to be recorded. 2 Start recording. Lights ¶ ÷ The recording level is adjusted automatically when the CRLS function is used. º ÷ Recording stops automatically when the tape side(s) to be recorded have been fully recorded. Knowledge sections 30 To repeat a recording Return to the recording start position. Press the rewind key during recording. During recording of reverse side (while 2 is lit) 1 ¡ Recording R-SG7/DP-SG7/X-SG7 (EN) ÷ If there is a non-recorded space of more than 4 seconds before the recording start position, recording is aborted and tape is rewound as shown below. Recorded tune Tune to be re-recorded Re-recording Blank of 4 sec. [. . . ] 1 Motors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Wow and flutter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 1 % (W. R. M. S. ) Fast winding time . . . . . . . . . . . . . . . . . . . . . . 110 seconds (C-60 tape) Frequency response TYPE I tape . . . . . . . . . . . . . . . . . . . . [. . . ]