User manual KENWOOD SK-EXNL2 FOR FORD EXPEDITION 2000-UP

[. . . ] SK-EXNL2 MOBILE VIDEO CONSOLE INSTRUCTION MANUAL FOR USE WITH KENWOOD MOBILE VIDEO PRODUCTS 2000-up Ford Expedition 2000-up Lincoln Navigator KENWOOD CORPORATION Take the time to read through this instruction manual. Familiarity with installation and operation procedures will help you obtain the best performance from your new mobile video system. Installation Accessories 4 - 8-32 Insert (KMSI832) 2 - #8 x 1/2" (KMSB832. 5) Black Machine Screw 2 - #8 x 1" (KMSB8321) Black Machine Screw 8 - #8 x 1/2" BlackSMS (KSMSB8. 5) 1 - Monitor Bracket (KMB701) 2 - 1/4-20 Star Nut (KSN1420) 2 - 5/16" Nylon Spacer (KNS8516) 2 - Air Controls Bracket (KMBFAC1) 2 - Mounting Bracket (pr. ) (KMBEXNL2) 4 - #6 x 1/4" Zinc SMS (KSMSZ6. 25) Notice that the brackets are drilled universally and will have two unused holes when mounted. [. . . ] Install wiring and cables according to the instructions provided with electronic equipment. Remove Factory Console If applicable, remove the console lid to allow access to the two screws that secure the rear portion of the console. Remove the two screws and reassemble the console lid. Open the cup holder and find and remove the four screws attaching the rear portion of the console. Pull firmly on the rear portion of the console to release the snap clips. Disconnect the wiring to the HVAC controls, rear radio controls, and the 12 volt power port. Remove the four screws attaching the radio controls and the four screws attaching the rear air controls (if equipped) to the back of the console. Save for reinstallation in the video console. Installation of Video Console Install the supplied mounting brackets to the factory console(refer to picture at right). Secure the mounting brackets to the mounting tab using the supplied #8 x 1/2" sheet metal screws through the bracket and into the factory speed clip. Notice that the mounting brackets are mirror images of each other and therefore have to be installed on their respective sides of the console. Mounting Bracket Make all electrical connections, including rear radio controls and the rear air controls (if equipped). Slide the video console onto the back of the factory console, making sure that it is as far down as possible. Mark and pre-drill a 3/32" hole in the console using pre-drilled hole in the upper part of the video housing as a guide. [. . . ] Secure the bracket through the holes in the air control and into the metal bracket using the supplied #6x1/4" sheet metal screws. Final Steps Reinstall all previously removed factory components and panels. Air Control Mounting Bracket Turn on and test everything. (If the system doesn't work properly, recheck all connections and fuses. ) The install of the video system is now complete. Rev 10-01-01 SK-EXNL2 Installed [. . . ]