User manual KENWOOD SK-SYTL1 FOR CHEVY AVALANCHE 2001-UP

[. . . ] SK-SYTL1 MOBILE VIDEO CONSOLE INSTRUCTION MANUAL FOR USE WITH KENWOOD MOBILE VIDEO PRODUCTS 2000-up 2000-up 2000-up 2001-up 1999-up Chevy Suburban GMC Yukon/XL Chevy Tahoe Chevy Avalanche GM Ext. Cab Trucks. KENWOOD CORPORATION Take the time to read through this instruction manual. Familiarity with installation and operation procedures will help you obtain the best performance from your new mobile video system. Installation Accessories 2 - #8-32 Inserts (KMSI832) Wiring and Connections 1 - Monitor Bracket (KMB701) Route all wires and cables at this time. [. . . ] Remove the video console and install one of the supplied metal inserts into the oblong hole on each side of the console, at the mark previously made. ) Re-connect the factory harness to the rear radio control unit. Re-install the video console and secure with (2) supplied #8-32 x 1/2" machine-thread screws through the pre-drilled holes in the plastic housing into the threaded inserts (Do not overtighten). Replace the two factory screws under the console lid towards Install Threaded Inserts the rear of the console. Figure 2 Remove Factory Console Open the console lid and remove the (2) screws toward the rear of the console. Fold down the cup holder on the rear of the console until it hits the stops. Continue to push down on the cup holder snapping it past the stops. Remove the (2) screws inside the cup holder recess. Unsnap the rear portion of the console and disconnect wiring. The rear radio controls (if equipped) will be relocated to the Q-View console. The power point can be relocated to the optional factory mounting location inside the console storage bin if so desired. (see picture at right) Factory Console NOTE: If installing into truck with console mounted air vents follow these instructions. Optional Power Port Location Remove the remaining five screws around the top edge of the console storage bin. [. . . ] The installation of your new Video System is now complete. Rev 10-01-01 Prepare Video Console Radio Control Unit Re-Installation: Fit the previously removed rear radio control box into the video console. If the vehicle was not equipped with rear radio controls, fit the supplied color-matched filler plate into the recessed area and secure with the (2) supplied #8 x 1/2" sheet metal screws through the predrilled holes into the plastic housing. SK-SYTL1 Installed [. . . ]