User manual KENWOOD TK-3360

[. . . ] The use of the warning symbol means the equipment is subject to restrictions of use in certain countries. This equipment requires a licence and is intended for use in the countries as below. We are grateful you have chosen Kenwood for your land moble rado applcatons. Government law prohbts the operaton of unlcensed rado transmtters wthn the terrtores under government control. [. . . ] Note: When first installing the belt clip, you must remove the battery pack from the rear of the transceiver . Remove the 2 screws from the rear of the transceiver, then remove the small, plastic black covering that was held in place. Insert the belt clip mount into the space on the rear of the transceiver . When the belt clip is not installed, leave the plastic covering in place . Do not use glue which is designed to prevent screw loosening when installing the belt clip, as it may cause damage to the transceiver. Acrylic ester, which is contained in these glues, may crack the transceiver's back panel . Note: To keep the transceiver water resistant, you must cover the speaker/ microphone jacks with the supplied cap. While holding the cap in place, push it towards the bottom of the transceiver until the tabs on the cap click into place . To remove the cap, hold the top of the cap in place with your finger while inserting a 3 mm or smaller flat blade screwdriver under the bottom of the cap. Slowly slide the screwdriver in until its tip touches the tab inside the cap, then gently pry the cap up (handle of screwdriver moving away from the transceiver) to remove the cap . Note: The transceiver is not fully water resistant when using a speaker/ microphone or headset . While holding the locking bracket in place, push it towards the bottom of the transceiver until the tabs on the bracket click into place . â· To remove the locking bracket, push the bracket up from the base . There are 3 types of stoppers available, depending on the number of channels used (4 channel type: white, 8 channel type: gray, and 2 channel type: black) . 1 set the selector knob to channel , then pull the selector knob off the transciever . If the selector is not positioned at channel , the selector knob may not install correctly and the channel may be unable to be changed . Power switch/ Volume control rotate to turn the transceiver on/oFF and to adjust the volume . Transmit/ Receive/ Battery low indicator If enabled by your dealer, lights red while transmitting, green while receiving a call, and orange or blue (depending on dealer programming) when receiving an optional signaling call (5-tone, dtmF signaling, etc . Blinks red when the battery power is low while transmitting. Auxiliary key press or hold to activate its programmable function {page 8} . PTT (Push-To-Talk) switch Press and hold this switch, then speak into the microphone to call a station . Side 1 key press or hold to activate its programmable function {page 8} . [. . . ] â· The Vox gain can be adjusted from levels to 0 and off . To transmit, simply speak into the microphone . When you finish speaking, transmission ends. If it is too sensitive, it will transmit when there is noise in the background. [. . . ]