User manual KENWOOD TK-8302

[. . . ] The use of the warning symbol means the equipment is subject to restrictions of use in certain countries. This equipment requires a licence and is intended for use in the countries as below. Information on Disposal of Old Electrical and Electronic Equipment and Batteries (applicable for EU countries that have adopted separate waste collection systems) Products and batteries with the symbol (crossed-out wheeled bin) cannot be disposed as household waste. Old electrical and electronic equipment and batteries should be recycled at a facility capable of handling these items and their waste byproducts. [. . . ] The left and right dots on the display can be programmed to indicate specific modes of operation, as listed below. The , , , , S, A, <B, C>, and keys can be programmed with the functions listed below. Ask your dealer for details on these functions. Direct Zone Channel can be programmed only on the S, A, <B, C>, and Emergency can be programmed only on the key. If the Transceiver Password function is programmed, "PS" will appear on the display when the power is turned ON. 2 Press C> to accept the entered digit and move to the next digit. When using a keypad, simply enter the password digits and proceed to step 3. Repeat steps and 2 to enter the entire password. If Squelch Off has been programmed onto a key, you can use that function to listen to background noise while adjusting the volume level. Select the desired zone and channel using the keys programmed as Zone Up/ Zone Down and Channel Up/ Channel Down. While scanning, the transceiver checks for a signal on each channel and only stops if a matching signal is present. The transceiver will remain on the busy channel until the signal is no longer present, at which time Scan resumes. Note: To use Scan, there must be at least 2 channels added to the scanning sequence. If a Priority channel has been programmed, the transceiver will automatically change to the Priority channel when a call is received on that channel, even if call is being received on a normal channel. During scan, you can temporarily remove specific channels from the scanning sequence by pressing the key programmed as Scan Delete/Add while Scan is paused at the undesired channel. However, when scanning is ended and restarted, the Scan settings return to normal. You can add and remove zones and/or channels to and from your scan list. 1 Select your desired zone and/or channel. 2 Press the key programmed as Scan Delete/Add to remove a channel or press and hold the key for approximately second to remove a zone. The Scan Revert channel is the channel selected when you press the PTT switch to transmit during scan. [. . . ] If a GPS unit (NMEA-03 format) is installed on your transceiver, you can press the key programmed as Send the GPS data to send your location data. This function opens the squelch only when the transceiver receives the 5 tones programmed in your transceiver. Transceivers that do not transmit the correct tones will not be heard. Note: Your transceiver functions include either 5-tone Signaling or FleetSync {page 9}, but not both. [. . . ]