User manual KENWOOD VR-5090

[. . . ] i Before Applying Power Read this section carefully to ensure safe operation. VR-5700/VR-5090/VR-5080 is designed for operation as follows. and Canada . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 120 V only ii Safety Precautions Read this section carefully to ensure safe operation. WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. [. . . ] · When the device is connected through a Kenwood system control cord, select System. In this case, the remote control signal is sent to the receiver then to the device connected to it. 01. CD 02. Tape 03. MD BackFFEnter Chapter Two : Setting Up the Remote Control Unit 10. Press the AV POWER button. MUSIC MOVIE TV 2. In step 6, select "Delete", "No Type" or by scrolling the device names. This makes Remote Control unit no longer identify the device. · If you select Delete, the setup is deleted together with the input name. For example, once you delete VIDEO1 to VIDEO3, the VIDEO1 to VIDEO3 inputs are skipped even when they are selected. · If you select No Type, the input name is displayed but only the registered device name is deleted. To program new functions in Extend1 to Extend5: 1. Select the controlled device (CD, DVD, etc. ) by pressing the MUSIC, MOVIE or TV button. REC AV POWER SYS. POWER Remote Setup Video1 DVD FFFFFFMenu Pressing the AV POWER button causes Remote Control unit to transmit the signal turning on/off the device being set. The device is turned on if the selected setup code is correct. If it is not turned on, select another code and press the AV POWER button again. In case it cannot be turned on by any code, see "If a device cannot be remote controlled with any code in the list, or to add remote control target functions. . . " on this page. Skip this step if System is selected in the setup code selection. If a device cannot be remote controlled with any code in the list, or to add remote control target functions. . . This Remote Control unit incorporates an advanced Learn function which makes it possible to program remote control signals used by another Remote Control unit in itself. If the setup code of a connected device is not contained in the Remote Control unit memory, program the code in Remote Control unit using this function. This function can also be used to change a setup code or add extended function to the remote control target. · Up to five extended functions per device can be programmed additionally in this Remote Control unit using "Extend1" to "Extend5" displayed on the LCD screen. The remote control signals transmitted by this Remote Control unit buttons can be changed. The signals from the buttons painted black in the following figure can be modified. Press the LEARN button. REC 40 11. After ensuring that the setup code is correct, press the Enter button. Set other devices by repeating steps 5 to 12 for each of them. [. . . ] 32 connecting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 identifying for Remote Control unit . . . . . . . 39 THX speaker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37 turntable/record player, connecting . . . . . . . . . . . . . . . . [. . . ]