User manual KENWOOD VR-707A

[. . . ] and Canada . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 120 V only Australia . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 240 V only Europe and U. K . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 230 V only China and Russia . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The adjustment can be made when the receiver is in the PCM stereo and analog stereo mode. Press the Loudness key to turn the LOUDNESS setting ON. (Multi %/ fi) Mute Tone VOL / Bass Boost Loudness Speaker EQ To cancel Press the Loudness key again so that the "LOUDNESS" indicator goes off. Active EQ Adjusting the TONE You can adjust the sound quality when the receiver is in the PCM stereo and analog stereo mode and when "THX OFF". 1 For the remote control, press and hold the TUNER key for more than 3 seconds to switch to receiver mode. 2 Press the TONE key to select the TONE mode. 3 Use the MULTI CONTROL knob or Multi (%/fi) keys to select TONE ON/OFF. SP L C SW R LFE AB MUTE CLIP COAXIAL DTS. DOLBY DIGITAL STEREO OPTICAL 6CH INPUT AUTO DETECT CINEMA EQ. MATRIX DSP MODE DISCRETE PRO LOGIC LOUDNESS ANALOG 96kHzfs NEO:6 CSII THX Surround EX RDS RTY AUTO MEMO STEREO TUNED Muting the sound The MUTE key lets you mute the sound of the speakers. Press the MUTE key. SP L C SW R LFE AB MUTE CLIP COAXIAL OPTICAL 6CH INPUT AUTO DETECT CIN AC DS ANALOG 96kHzfs SL S SB SR Blinks To cancel Press the MUTE key again so that the "MUTE" indicator goes off. · MUTE ON can also be deactivated by turning the VOLUME CONTROL knob or pressing VOL +/­ keys. SL S SB SR 4 When in TONE ON selection, press the TONE key for the following displays. BASS : Select this to adjust the low frequency range. TREBLE : Select this to adjust the high frequency range. · SPEAKER EQ function will not be available when REC MODE, AUTO TUNING, PRESET MEMORY or DTS-ES MATRIX is ON, and during 96kHz LPCM playback. 1 SPEAKER EQ SMALL 3 Use the VOLUME CONTROL knob or VOL +/­ keys to adjust the volume. 26 EN Recording Recording audio (analog sources) 3 Press and hold the DIMMER key for more than 2 seconds to select the AUTO REC or MANUAL REC mode. 1 REC MODE off : The digital input record mode is switched off. 2 AUTO REC mode : The digital input signals (DTS, Dolby Digital, or PCM) are identified automatically and converted into stereo signals that are ready for recording. 3 MANUAL REC mode : The input signal type at the moment this mode is selected is held throughout this mode. DOLBY DIGITAL STEREO OPTICAL 6CH INPUT AUTO DETECT CINEMA EQ. MATRIX DSP MODE DISCRETE PRO LOGIC LOUDNESS ANALOG 96kHzfs NEO:6 CSII THX Surround EX RDS RTY AUTO MEMO STEREO TUNED MD/TAPE Recording a music source 1 Use the Input Selector keys to select the source (other than "MD/ TAPE") you want to record. 2 Set the MD or TAPE recorder to record. 3 Start playback, then start recording. L C SW R LFE AB COAXIAL SL S SB SR Recording video 1 Use the Input selector keys to select the video source (other than "VIDEO 1") you want to record. 2 Set the video deck connected to VIDEO 1 to record. · Select the REC MODE to record a digital input source. [. . . ] 87. 5 MHz ~ 108. 0 MHz Usable sensitivity (MONO) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 3 µV (75 )/ 13. 2 dBf (75 kHz dev, SINAD 30 dB) 50 dB quieting sensitivity STEREO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 µV (75 )/ 40. 2 dBf Total harmonic distortion MONO (1 kHz, 75 kHz dev) . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 5% (65 dBf input) STEREO (1 kHz, 67. 5 + 6. 75 kHz dev) . . . . . . . . . [. . . ]