User manual KETTLER RIGA

[. . . ] All KETTLER products are designed in accordance with the latest safety regulations and undergo a constant process of quality control during manufacturing. The knowledge gained in this process is used to constantly improve and develop our products. In order to offer our customers the very best in product quality, we reserve the right to make technical changes at any time. [. . . ] Correct repairs, alterations to the design (removal of original parts, addition of other components etc. Ularly to ensure that they are in good condition. Do not use the table-tennis table until it has been fully and cor- For practising without a partner, the table halves can be folded Ensure that table-tennis tables which are not weatherproof are For more information on the sport of table-tennis, you are re- Keep them well away from direct sources of heat. Should the surface become warped, lay the table on a level surface for a few days. Do not cover it with plastic foil, under which condensation may Do not use corrosive or abrasive materials to clean the equip- Ensure that such materials are not allowed to pollute the environment. The fastening material required for each assembly step is shown The equipment must be assembled with due care by two adult Ensure that you have received all the parts required (see check Should you have any cause for complaint, please contact your KETTLER dealer. Before assembling the equipment, study the drawings carefully Use the fastening material exactly as instructed. Bolt all the parts together loosely at first, and check that they And carry out the operations in the order shown by the diagrams. The correct sequence is given in capital letters. Please note that there is always a danger of injury when work- Ing with tools or doing manual work. Therefore please be careful when assembling this machine. Ensure that your working area is free of possible sources of dan- Tighten the locknuts by hand until resistance is felt, then use spanner to finally tighten nuts completely against resistance (locking device). Then check that all screw connections have been tightened firmly. Attention: once locknuts have been unscrewed they no longer function correctly (the locking device is destroyed), and must be replaced. [. . . ] Carry out steps 5­8 for the second half of the table. Again, ensure that the table cannot slip or tilt over!Hold the table firmly with one hand, press the left-hand lock and lower the table-half slowly into position. [. . . ]