User manual KETTLER RODEO

[. . . ] (Check regularly with the age of the child). This child's bicycle seat is not suitable for fully sprung bicycles. The child's seat can be used for bicycles with a minimum wheel diameter of 26 inches; the diameter of the frame tube must be 28, 30, 32, 35 or 40 mm. Any other use is inadmissible and may even be dangerous. [. . . ] Repair works done by non-experts and alterations to the construction (dismounting original parts, attachment of parts without approval etc. Attention: Please note that the riding behaviour of the bicycle may change with a child in the seat, especially regarding balance, steering and braking. Sudden weight transfers by the child may considerably affect your safety during the ride. Attention: Never park the bicycle with the child still in its seat. Attention: Do not use the seat if one of its components is defective. Damaged components may jeopardize your or the child's safety. Before going on a ride you should check all components for potential damage and loose connections (screws, connections, safety belts etc. Attention: In case of extreme weather conditions please check if the seat can be used by the child, as for example the seat may become very hot when there is strong solar radiation, or if the temperature is far below freezing point the skin may stick to the seat or its components. The child's seat must be positioned such that it is not in contact with the luggage carrier. The distance between luggage carrier and tube shackle must be min. This results in a seat which is slightly inclined towards the rear such that the child may not slide out of the seat. the seat back is slighty inclined to the rear. The load centre (marked by a red point) may only be within 10 cm behind the wheel hub (explained in detail below). In case of saddles with uncovered springs the latter have to be covered as a protection against bruises (e. Further to that the rear wheel is provided with an additional cover on the spokes or a protective device to prevent dresses from getting mingled with the spokes. Check the tight fit of all screwed connections after assembly. Please check whether all parts of the bike operate correctly with the set fitted in place (e. Always use environmentally friendly substances, never aggressive or caustic ones, for cleaning and servicing the child's bicycle seat. If necessary you may also clean the safety belts. In this case it is especially important not to use aggressive substances! usually weak washing-up water or a mild detergent will be sufficient. If seat or clothes are damp the colour of the seat may possibly mark pale coloured clothes due to friction. [. . . ] Clean the contact surfaces before attaching the Velcro strip. Pull off the film from the Velcro strip and press the pads firmly onto the armrests. For cleaning pull the upholstery from the armrest and loosen the screw at the bottom from the seatstay. After cleaning you must refasten the upholstery. [. . . ]