User manual KEYENCE E28

[. . . ] If masking is not possible, contact your local representative for replacement labels. 13. To actuate apply the appropriate voltage signal to actuating valve. Turn the adjusting screw in 1/8 increments, clockwise to increase opening time. Turn the needle counterclockwise to decrease opening time. [. . . ] Prior to reassembly lubricate the threads with grease Lubriplate 630-AA or equivalent and o-ring with Magnalube-G. If needle is damaged, replace cap assembly. The electric actuating valve solenoid can not be serviced internally. If the solenoid fails to operate, remove the solenoid and replace. INSTALLATION 1. Do not install until you have read the entire product information sheet. Maximum pressure rating is 150 psig (10. 3 bar). Temperature range is 40°F to 150°F (4. 4°C to 65. 5°C). Prior to installation, insure that the pressure in the air line where this product is to be installed is depressurized (0 psig). It is recommended to install an appropriate Wilkerson filter upstream of the unit for maximum trouble free operation. Install with the air flow in the same direction as the arrow on the unit. AVOID restricting the air flow with undersize piping or fittings, unless maximum flow is not required. Install the valve to the top of the unit. Follow the supplied instructions with actuating valve for proper installation and wiring if using an electric solenoid actuating valve. There are two exhaust ports, one in the rear of the unit and one on the down stream side of the unit cap. INSTALL THE PIPE PLUG IN THE EXHAUST PORT THAT WILL NOT BE USED. !WARNING FAILURE OR IMPROPER SELECTION OR IMPROPER USE OF THE PRODUCTS AND/OR SYSTEMS DESCRIBED HEREIN OR RELATED ITEMS CAN CAUSE DEATH, PERSONAL INJURY AND PROPERTY DAMAGE. This document and other information from The Company, its subsidiaries and authorized distributors provide product and/or system options for further investigation by users having technical expertise. It is important that you analyze all aspects of your application, including consequences of any failure and review the information concerning the product or systems in the current product catalog. Due to the variety of operating conditions and applications for these products or systems, the user, through its own analysis and testing, is solely responsible for making the final selection of the products and systems and assuring that all performance, safety and warning requirements of the application are met. The products described herein, including without limitation, product features, specifications, designs, availability and pricing, are subject to change by The Company and its subsidiaries at any time without notice. EXTRA COPIES OF THESE INSTRUCTIONS ARE AVAILABLE FOR INCLUSION IN EQUIPMENT / MAINTENANCE MANUALS THAT UTILIZE THESE PRODUCTS. CAUTION: If plug is not installed securely, plug may dislodge when valve exhausts and could possibly cause injury. 10. [. . . ] VRP-95-785 Muffler Exhaust Location WIRING INSTRUCTIONS FOR CABLE PLUG 1. Remove the holding screw (A) from the cable plug, and pry the contact holder (B) from the plug case (C) (see Figure 1). Remove the gland nut (D), thrust washer (E) and gland (F) from the plug case and slide each part over the multiconductor cable in the order removed. Insert cable through the plug case (see Figure 2). [. . . ]