User manual KIDDY DISCOVERY PRO

[. . . ] Improper installation can endanger the life of your child. Use the child restraint system only for weight classes II to III (from 15 kg up to 36 kg maximum). Check to make sure the child restraint system is properly adjusted to the size of your child prior to travel. Do not attempt to make adjustments during travel. [. . . ] The kiddy discovery pro's adjustable seatback ensures that it can rest securely against the car seatback. 1 Adjusting the head and shoulder support The kiddy discovery pro provides optimum adaptation to the size of your child by means of its innovative adjustment system. WRONG: too low RIGHT WRONG: too high The correct headrest setting is achieved when the head of your child lies at the midline of the headrest. To adjust the head and shoulder supports, grasp the yellow height adjustment handle on the back of the headrest and pull it out gently, while simultaneously raising or lowering the headrest to the desired height (Fig. After adjusting the height, lock the headrest again in the nearest available position. You can check to see that the headrest is firmly locked in place by gently pressing down on it. 2 Adjusting the seat bottom (thigh support) You can achieve significantly better seating comfort for your child by adjusting the thigh support, which can be set in four positions (Fig. Step 1: Lift up gently on the thigh support extension. Step 2: Pull the extension out to the desired position and lock it into place. In order to adjsut the recline position, unlock the belt system and fold back the support bracket until it lies evenly against the seat back of the car seat. The recline position may be used only for children with a weight up to 18kg. Position your kiddy in your vehicle seat as described in Section 4. Check to see whether your kiddy is adjusted to the size of your child (Section 5). Open the belt guide on the side across from the belt buckle by pressing the hook back (step 1) and then down to open (step 2). Thread the shoulder belt between the headrest and the shoulder support, and place it in the belt guide. Now close the belt guide by pressing it up into the lock (step 1). Check to see that whether the belt guide is properly closed (locked in place). Then pull the buckle tongue under the armrest on the belt buckle side and fasten it with a noticeable "click. " Make sure that the belts are not twisted and lie snugly along the body of your child. also check that the belt buckle is correctly positioned. Now tighten lap belt (step 1) and then the diagonal belt (step 2) in the direction of the automatic belt ratchet. For safety reasons, the belt guide cannot be opened in the lowest headrest positions. [. . . ] 2 Cleaning plastic parts The plastic parts can be cleaned with a mild cleanser or with a damp cloth. After an accident with an impact speed greater than 10 km/h, the child restraint system must be sent back to the manufacturer without fail, to be checked for possible damages and replaced at no charge if deemed necessary. For the kiddy discovery pro we extend a warranty against defects in materials and workmanship for up to two years. The warranty covers child restraint systems that have been handled properly and are returned in a clean and orderly condition. [. . . ]