User manual KIDDY EVOCITY 1

[. . . ] DE EN NL FR SI DK ES PL Bedienungsanleitung Directions for use Gebruiksaanweijzing Guide d’utilisation Navodila za uporabo Brugsanvisning Manual de uso Instrukcja Obsługi Downloaded from www. Com manuals search engine 1 2 3 3 4 1 2 2 1 3 4 5 1 6 1 2 7 2 8 Downloaded from www. Com manuals search engine STOP 2 1 GO STOP 9 a b 2 c 10 GO d 1 11 3 12 13 1 14 2 15 16 Downloaded from www. Com manuals search engine 17 18 1 2 19 20 1 2 1 2 21 22 3 2 23 1 24 Downloaded from www. [. . . ] To loosen the brake push the brake levers upwards (fig. 8 Adjustment of the reclined/upright position To change the reclining position, pull the adjust button upwards (fig 11; no. 1), then change the position of the back rest (fig 11; No. 3) so that the back rest is fixed in one of the 4 possible positions (fig 11; a-b-cd). The most reclined position (d) is intended to use for new born babies. 9 Adjustment of the footrest Pull the buttons on the left and right side of the footrest forwards (fig. 1) and adjust the footrest to the desired position (fig. WARNING After adjustment make sure that both buttons are engaged. Securing the child with the 5-point belt system WARNING Avoid serious injury from falling or sliding out. Com manuals search engine EN Always use the 5-point belt system as described below when you use your Evocity 1 with seat unit. 1 Opening the 5-point belt system Push the button in the middle of the buckle (fig. 2 Width adjustment of the 5-point belt system and securing the child Place your child in the seat unit, put the shoulder belts over childs shoulder and the buckle between the legs. Push the buckle tongues into the buckle and ckeck if it is closed. The belt system can be adjusted by sliding the 5 belt adjusters in the desired direction (fig. WARNING The belt system is adjusted correctly when the belts lay firmly on the childs body. 3 Height adjustment of the shoulder belts Push the plastic clip on the backside of the backrest through the hole to the front (fig. Now insert the plastic clip into the hole at the required height (fig. The plastic clip must lay flat on the backside of the backrest. To secure children from 0 up to 6 months by the harness system, thread before the 2 shoulder belts through the 2 loops (fig. 16) and recline the backrest to the lowest position. Com manuals search engine EN WARNING Make sure that both shoulder belts are fixed at the same height. 4 Opening/closing the bumper bar To open the bumper bar, press the release button (fig. [. . . ] 2 Removing and mounting the cover Remove the sunroof like like described in section 3. To remove the seat cover open 5 snap fasteners at the side of the seat and backrest(fig. Open the snap fasteners on the second side also. Open then the 2 connecting belts under the seat (fig. [. . . ]