User manual KIDDY FIX

[. . . ] It will then always be handy when needed. Use only kiddy child car safety seats and original accessories approved by the manufacturer and do not make any modifications to the product!In case of any doubt, always contact your specialist dealer, the importer or manufacturer. Inspect the ISOFIX connectors (A) before every trip to ensure that they are connected to the vehicle and the supporting leg and base (F/G) is properly adjusted. [. . . ] Empty batteries can be disposed of free of charge at specialist dealers, where batteries are sold. Never use another attachment (bracket) than described in this manual or on the product label!Prior to installation, check whether your vehicle is fitted with ISOFIX brackets (metal brackets between the seat and backrest) and consult the vehicle type list and vehicle user manual! For this purpose, pull the yellow support base handle (I) at the front (Fig. 1), slide the support base (G) slightly inwards and fold the support leg (F) out (Fig. This closes the power circuit for the electric release and the sound signals. You kiddyfix is now automatically switched on. The support leg (F) must be folded out prior to installation in the vehicle. Now check whether the anchoring system of your kiddyfix is released by pressing both yellow ISOFIX unlatching buttons (E) at the top on the sides of the support leg (F) (Fig. Press (click) both funnels guides (M) onto the brackets between the seat and backrest of the vehicle seat (Fig. Proper latching is confirmed by a sound signal as well as the green ISOFIX display (E) (Fig. Now slide the yellow connectors (L) onto the metal brackets and press tightly against it. Check that the mechanical parts latch in correctly by trying to retract the support base (G) without activating the support base handle (I). If the support base (G) is not moving, it is properly latched. Your kiddyfix must always be used with folded out and correctly adjusted support base (G)!To achieve this, activate (1) the yellow support base handle (I) and pull the support base (G) out until it stands firmly on the floor of the vehicle and both support foot displays indicate red (Fig. The final installation step is to adjust the support base (G). Prior to every trip, check whether all systems are correctly latched, or adjusted. Now you can install your kiddy child safety car seat according to its instruction manual on the kiddyfix (A). Now you can start with dismantling the platform (A). First remove the kiddy child safety car seat from the kiddyfix platform (A) as explained in its instruction manual. Keep both ISOFIX unlatch buttons (E) pressed in and simultaneously pull the platform (A) from the brackets downwards to the front (Fig. [. . . ] Because it contains electric components, your kiddyfix may under no circumstances be cleaned under running water. Movable parts should never be lubricated. After an accident resulting from a speed of more than 10km, it is imperative to have your kiddy be checked by the manufacturer for possible damage and then replaced if necessary. For your kiddy we extend a warranty against defects in materials and workmanship for up to 2 years. [. . . ]