User manual KING TECHNOLOGY POOL FROG XL PRO IN GROUND MINERAL SYSTEM (ENGLISH)

[. . . ] Pool FROG XL PRO In GROUND MINERAL SYSTEM FOR POOLS TM Patented Mineral Pool Sanitizer MINERAL RESERVOIR CHLORINE PAC G L FRO POO SERVOIR THE L RE RA ACED MINE BE REPL THS MUST SIX MON OOL Y P EVER ER ONE VER T F HE OR A N WHIC . O R SEAS SHORTE IS ® Model 5450 Instruction Manual Customer Service 800-222-0169 TABLE OF CONTENTS POOL FROG Introduction ® 3 4 5-6 Swimming Pool Tips Start-up and Operation Replacing POOL FROG Mineral Reservoir ® 7 8 Replacing FROG BAM ® Replacing POOL FROG Pac ® 9 10 11 12 12 13 14 15 16 Troubleshooting Parts List Replacing Control Dial O-Rings Replacing Cap O-Ring and Knob Winterizing In-line Installation For Proper Performance Warranty For information on King Technology's entire product line, visit our website at www. kingtechnology. com POOL FROG ® Welcome to easier pool care courtesy of POOL FROG XL PRO. With POOL FROG XL PRO, your pool water will look and feel better without a lot of work or a lot of chlorine. This system controls bacteria using a combination of minerals and reduced chlorine levels-up to 50%* less. [. . . ] Metals in the fill water may have been oxidized. Shock the pool and clean the filter until water clarity returns. 2. Algae may be trying to form ­ shock the pool, increase circulation time if needed and clean the filter. 3. Check with your dealer for more information. 3. What do I do if algae forms in or on my pool? 1. Use a nonmetallic (polyquat) algaecide per the directions on the bottle and brush the sides of the pool often. Clean the filter and shock the pool with chlorine daily until water clarity returns. 3. If you are in an area of the country that struggles with algae growth, see your dealer regarding a 90-day Algae Protection Guarantee using ® FROG BAM . See product hang tag for guarantee details. 4. Check with your dealer for more information. 4. What do I do if I am under chlorinating with the POOL FROG® Pac? 1. If you are unable to maintain 0. 5 to 1. 0 ppm, first make sure there are chlorine tablets in the ® tower areas of the POOL FROG Pac and it is installed properly. If a correction was made, test the water in 24 hours. If still low, turn the dial up one setting and test the water again in 24 hours. Continue raising the setting by one increment each day until the proper reading is achieved. Shock the pool if the reading has been lower than 0. 5 ppm for more than one day. Contact your dealer to have your back pressure tested to ensure it is between 3 & 8 psi. Contact King Technology's Customer Service Department at 800-222-0169. 5. What do I do if I am over chlorinating with the POOL FROG® Pac? 1. If the chlorine reading is over 3. 0 ppm, remove the Chlorine ® Pac from the POOL FROG Chlorine Cycler and test the water daily until the reading is down to 1. 0 ppm. Reinsert the POOL FROG Pac, lower the dial one setting ® and test the water again in 24 hours. If the reading has risen, lower the dial one setting again. Continue this process until proper reading is achieved. If over-chlorinating at the lowest possible setting, consider decreasing the circulation time. Depending on your pump size, you may be circulating the water more than is necessary which results in more chlorine than is necessary. [. . . ] Purchaser must present the sales receipt or other documentation verifying proof of purchase. This warranty does not cover defects caused by: Modification, alteration, repair or service of the unit contrary to the accompanying instructions; physical abuse to or misuse of the product or operation or installation in a manner contrary to the accompanying instructions. This warranty also excludes all costs arising from the installation, adjustment, removal or replacement of defective units or parts. This warranty also excludes any and all claims arising out of the chemicals used in the product or their characteristics. [. . . ]