User manual KINGSTON SH100S3B

[. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operations. This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Attach the other end of the SATA interface cable to the SSD. Attach the power cable or power adapter (provided) to the SSD. You are now ready to copy your data from the system hard drive to the SSD using the cloning software provided. Insert the Acronis True Image HD software into the system CD-ROM drive. The Acronis True Image HD CD is a bootable disk and will boot to the Acronis True Image HD screen. Note: If the system does not boot to the Acronis True Image HD screen and instead boots to Windows, perform the following: 1) Restart the computer. While the system is restarting, run the system setup program (BIOS). The BIOS can be activated by pressing a special key such as ESC, F1, F12 or DELETE. (Refer to your system manufacturer’s documentation for the correct key. ) 2) While in the system BIOS, change the boot order so that CD-ROM is the first boot device. (For more detailed instructions on configuring the BIOS, consult your system manufacturer’s documentation. When the computer restarts, it should now boot to the Acronis True Image HD page. Select the Acronis True Image icon from the Acronis True Image HD screen (Figure 3). Note: It may take a few minutes for the next screen to come into view. Figure 4: Select Clone Disk 9 SSD Desktop / Notebook Note: If you receive an error message stating “This program is designed to work with two or more drives, ” check all connections to both the hard drive and the SSD. Ensure that the SATA data and power cables are connected to the drives and motherboard. If all connections are in place, it is possible that your system BIOS does not have the spare SATA ports turned on or enabled. If this is the case do the following: 1) Restart your computer. While the system is restarting, activate the system setup program (BIOS) by repeatedly pressing a special key such as ESC, F1, F12 or DELETE. (Consult your computer system’s documentation for the correct key). 2) While in the system BIOS, look for an entry labeled “Drives or Hard Drives. € Select this field using the arrow keys on your keyboard and press Enter. [. . . ] Note: If the system does not boot to the Acronis True Image HD screen and instead boots to Windows or fails to boot at all, perform the following: 1) Restart the computer. While the system is restarting, run the system setup program (BIOS). The system BIOS can be activated by pressing a special key such as ESC, F1, F12 or DELETE. (Consult your computer system’s documentation for the correct key. [. . . ]