User manual KINGSTON SNV125-S2BD

[. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operations. This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Refer to your system manufacturer’s documentation for instructions. Attach one end of the SATA data cable (provided) to the SATA interface connector on your computer’s motherboard or SATA host adapter. Below is an example of what a motherboard SATA connector might look like: SATA connector Figure 2: Desktop PC motherboard with 4 SATA connectors. The number of connectors on each system will vary. Note: SATA connectors are keyed to ensure correct orientation. Attach the other end of the SATA interface cable to the SSD. Attach the power cable or power adapter (provided) to the SSD. You are now ready to copy your data from the system hard drive to the SSD using the cloning software CD provided. Setup and Use Acronis® True Image HD IMPORTANT: ** It is strongly recommended that you uninstall any Trial versions of Acronis software prior to installing full versions. Insert the Acronis True Image HD software CD into the system CD-ROM drive. The Acronis True Image HD CD is a bootable disk and will boot to the Acronis True Image HD screen. Note: If the system does not boot to the Acronis True Image HD screen and instead boots to Windows, perform the following: 1) Restart the computer. While the system is restarting, run the system setup program (BIOS). The BIOS can be activated by pressing a special key such as ESC, F1, F12 or DELETE. (Refer to your system manufacturer’s documentation for the correct key. ) 2) While in the system BIOS, change the boot order so that CDROM/DVD is the first boot device. (For more detailed instructions on configuring the BIOS, consult your system manufacturer’s documentation. When the computer restarts, it should now boot to the Acronis True Image HD page. Select the Acronis True Image HD icon from the Acronis True Image HD screen (Figure 3). Note: It may take a few minutes for the next screen to come into view. [. . . ] Note: Your original system hard drive can now be used as a secondary data disk for data storage and should be viewable via My Computer (Computer in Vista). Figura 5: Asistente de clonación de disco Nota: Si recibe el mensaje de error «This program is designed to work with two or more drives», compruebe todas las conexiones del disco duro y la SSD. Abbildung 5: der Kopierassistent Hinweis: Wenn die Fehlermeldung „This program is designed to work with two or more drives“ ausgegeben wird, prüfen Sie alle Verbindungen zwischen der Festplatte und dem SSD. Remove the Acronis True Image HD software CD and close the program. [. . . ]