User manual KINGSTON SNVP325-S2B

[. . . ] (2) This device must accept any interference received, including interference that may cause undesired operations. This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Remove the system chassis cover according to the system manufacturer's instructions. Attach the 2. 5" to 3. 5" mounting brackets (provided) to the SSD by aligning the mounting screw holes on the brackets with those on the SSD and inserting the M3 flat head screws provided. Locate an available 3. 5 inch drive bay inside your computer and install the SSD using the 6/32" pan head screws (provided). Note: Your system may require proprietary chassis screws, rails or a bracket system to be used with its drive bay(s). If this is the case, please attach that hardware to the 2. 5" to 3. 5" mounting bracket for compatibility with your computer chassis. Refer to your system manufacturer's documentation for instructions. Attach one end of the SATA data cable (provided) to the SATA interface connector on your computer's motherboard or SATA host adapter. Below is an example of what a motherboard SATA connector might look like: SATA connector Figure 2: Desktop PC motherboard with 4 SATA connectors. The number of connectors on each system will vary. Note: SATA connectors are keyed to ensure correct orientation. Attach the other end of the SATA interface cable to the SSD. Attach the power cable or power adapter (provided) to the SSD. You are now ready to copy your data from the system hard drive to the SSD using the cloning software CD provided. Setup and Use Acronis® True Image HD IMPORTANT: ** It is strongly recommended that you uninstall any Trial versions of Acronis software prior to installing full versions. Insert the Acronis True Image HD software CD into the system CD-ROM drive. The Acronis True Image HD CD is a bootable disk and will boot to the Acronis True Image HD screen. Note: If the system does not boot to the Acronis True Image HD screen and instead boots to Windows, perform the following: 1) Restart the computer. While the system is restarting, run the system setup program (BIOS). The BIOS can be activated by pressing a special key such as ESC, F1, F12 or DELETE. (Refer to your system manufacturer's documentation for the correct key. ) 2) While in the system BIOS, change the boot order so that CDROM/DVD is the first boot device. (For more detailed instructions on configuring the BIOS, consult your system manufacturer's documentation. ) 4) Restart the computer. When the computer restarts, it should now boot to the Acronis True Image HD page. 7 SSDNow For Desktops 4. [. . . ] Once the cloning process is complete, a Disk Cloning was successful window will appear. Remove the Acronis True Image HD software CD and close the program. 11 SSDNow For Desktops Set "Hard Drive Boot Priority" Your system is now configured with two bootable drives. In order to boot from your new SSD drive, you must enter the system BIOS to set "Hard Drive Boot Priority" so that your new SSD drive is set to boot first. [. . . ]