Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual KINZO 25C19. We hope that this KINZO 25C19 user guide will be useful to you.
Lastmanuals help download the user guide KINZO 25C19.
Detailed instructions for use are in the User's Guide.
[. . . ] A) Your hammer drill has been designed for drilling in concrete, stone, wood and steel and for light chipping and chiseling applications. WARNING Read this manual carefully before using the machine, for your own safety. SAFETY INSTRUCTIONS When using the machine, always observe the enclosed safety instructions as well as the additional safety instructions. [. . . ] A) The machine must be set to the required function (drilling, hammer drilling or chiseling) before use. I For drilling without hammering (in soft stone, wood or steel) you turn the hammer function switch (2) to position and the chisel function switch (3) to position . In this position the drill chuck does not rotate. Only set the hammer functions (2) and (3) when the machine is switched off. B) The dust collector is used for drilling into ceilings. I Slide the dust collector (10) onto the shaft of the bit and mount the bit as described above in the drill chuck. Instructions for use I Before inserting a drill bit or chisel, always grease the shaft. I When a cold machine is to be used for chiselling, first let it run idle for a few minutes to allow the grease to spread in the mechanism. I If the machine does not hammer properly, first check if the switch is in the hammering position and if the drill bit or chisel is correctly fitted. I The separate chuck cannot be used for hammer drilling!I Vibrations may cause slight leakage of oil through the joints of the housing. In this case, you need to tighten the bolts. To switch off the machine, release the on/off switch. A) The carbon brushes must be checked on a regular basis. i Remove the carbon brush holders (9) and clean the carbon brushes. I In case of wear, replace both carbon brushes at the same time. [. . . ] - The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. För mejsling vrider du slagfunktionens och omkopplare (2) till läget mejslingsfunktionens omkopplare (3) till läget . I För borrning utan slagfunktion (i mjuk sten, trä eller stål) vrider du slagfunktionens omkopplare (2) till läget och mejslingsfunktionens omkopplare (3) till läget . [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE KINZO 25C19
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual KINZO 25C19 will begin.
