User manual KLIPSCH 28K

[. . . ] This is a particularly good idea if you wish to take fulr advantage of any future upgrades or options. CAUTION: Never ship your 28K Remote Control Preamplifier without the original packing. CONTENTS OF THIS CARTON: This carton contains: your new 28K Remote Control Preamplifier, a hand held remote transmitter, batteries for the remote control, a UL approved power cord, a Warranty Registration/Survey card, and of course, this Owner's Manual. Please follow the instructions contained in this manual in order to derive the maximum performance, flexibility and enjoyment from your 28K Remote Control Preamplifier. [. . . ] TAPEOUTPUTS These are fixed level outputs for use with recording devices. PREAMPOUTPUTS These are variable level outputs for use with your power amplifier. These are 11. RPC120 CONNECTOR This mini jack connector is for optional RPC120 Power Station. A/C POWERCONNECTOR the This three prong connector isfor the A/C power cable. SYSTEM SETUP AND OPERATION This section provides you with the setup procedures and functions to easily connect and operate the 28K Remote Control Preamplifier in your system. INPUTS Before inserting or removing any connectors be certain both the preamp and power amp are OFF. Using the appropriate RCA cables connect your source to the corresponding input on the rear panel. The audio output of a video source can be connected to any input. Consult you Aragon dealer for his or her recommendations on RCA cables. OUTPUTS Connect the input of your tape recorder to the tape outputs on the back panel of the preamp. Connect the input of your power amp to either preamp output connector. Two preamp outputs are provided to facilitate the use of two power amps or a subwoofer if desired. AC INPUT After you have finished with all of your input and output connections plug the female end of the provided AC line cord into the 3-pronged lEG socket on the rear panel. Plug the optional RPC120 Power Station into the AC Power Control Output on the back of your 28k. When connected, this will allow the turn-on/off of your entire audio system by simply turning on/off your 28k. The AC switching is performed externally to eliminate the additional noise associated with high current AC power in proximity to the sensitive analog circuitry. POWER I MUTE SELECTOR When the Power/Mute switch is rotated clockwise to the Power position, the LED will flash red for approximately 3 seconds (initializing) then turn green, indicating that the preamp is in operating mode. Rotating the switch clockwise with the 28k on will shut the preamplifier off and the LED will go out. With the 28k on, rotating the switch counter clockwise to the Mute mode will mute the Preamp outputs (not Record) of the 28K and the LED will turn red. [. . . ] Clockwise from the left, the sequence is; TAPE 1, TAPE 2, AUX, TUNER, DIA, CD. RECORD By rotating the Record knob you select the source you wish to record from. Clockwise from the left the sequence is; CD, DIA, TUNER AUX, TAPE 2, TAPE 1. [. . . ]