User manual KLIPSCH 8008

[. . . ] thoroughly tested and carefully packed at our factory In California. In the unlikely event that your 8008 Balanced is damaged during shipment. be sure to save the carton as evidence for the freight carriers' Inspection and call your authorized dealer Immediately. We strongly recommend that you always save the box and packing materials should you have to transport your 8008 Balanced for any reason. [. . . ] LEFT SPEAKER OUTPUT". " This is the Input for the right channel when using an RCA single ended channel source. 5. RIGHT SPEAKER OUTPUT "+" These are the "-" outputs for the left channel speaker. 11. A/C POWERCONNECTOR These are the" +" outputs for the right channel speaker. 6. RIGHT SPEAKER OUTPUT". " This3 prong connector is for the A/C power input. 12. LINE FUSEHOLDER These are the "-" outputs for the right channel speaker. Thisis the A/C fuse protection holder. Negative Signal FIGURE INPUT 3 SELECnON JUMPER SYSTEM SETUP This section provides you with the setup procedures to easily connect the 8008 Balanced Amplifierto your system. Never allow the speakercable termination'sto touch at either the back of the amplifier or the speakerterminals. Alwaysturn off the 8008Balanced when connecting or moving your loudspeakers. Your 8008Balanced Isdesigned to be free standing, placed on (;Inaudio rack or stacked with other components. Alwaysbe sureto provide enough space (at least 1'/2 Inches)at the top and the rear of the 8008Balanced to allow sufficientair flow through the ventilation slots. Failureto do this will cause severedamage to the unit. Never place your 8008Balanced directly on carpet. Alwaysplace on a hard flat surface to allow far proper ventilation. SETUP WITH AN AUDIO SYSTEM 1. PREPARAnON Before hooking up your 8008 Balanced you must decide if you will use the single ended or balanced Inputs. either may be used with similar performance. Your 8008 Balanced was shipped to you with a jumper between pins 1 and 3 on both of the XLRconnectors. To use the amplifier in single ended (RCA Inputs) mode. leave the jumper in place on both XLR connectors. To use the amplifier In balanced (XLRinputs) mode. remove the jumper on both XLR connectors. [. . . ] It Isvery important to make sure . +"'5to "+"and "-"Isto "-". 4. POWER CONNECTION Plugthe A/C power cord Into the back of your 8008Balanced and then into your A/C wall outlet. SPECIFICATIONS 8008Balanced Dual Mono Amplifier Power Output: 8 ohms 200 watts per channel continuouspower both channels driven 5Hz 20KHzat lessthan 0. 04%THO 400 watts per channel continuous power both channels driven 5Hz-20KHz - 4 ohms Input Impedance: SingleEnded 22Kohms Balanced 44Kohms Input Sensitivity: 1Watt Output 120mV FullOutput 1. 68V SignalTo Noise: AWeighted> 110dB Damping Factor: >500 SlewRate: >120V/~S Voltage Gain: 28 dB PhaseInversion: No Weight: 75 Ibs. Size: 19W x 145/8 D x 6 5/8 H TROUBLESHOOTING Simple Solutions to Simple Problems NO SOUND A. Check A/C Power connection on back of 8008 Balanced and A/C receptacle. [. . . ]