User manual KLIPSCH 8008 MKII

[. . . ] If there is no noise, the problem is not with the amplifier, but This Warranty is only valid for the original purchaser and will automatically may be system-related. Reconnect the preamplifier and disconnect terminate prior to expiration if this product is sold or otherwise transferred to another party. If the hum returns, it is either coming from the preamplifier, or is the result of a ground This Warranty does not cover cosmetic damage or damage due to misuse, loop between the preamp and amplifier. Ensure that both pieces are abuse, negligence, acts of God, accident, commercial use or modification plugged into the same A/C outlet. [. . . ] Contact the dealer from whom you purchased the Five-way Binding Post Speaker Output amplifier, as they should be able to check and change the fuse for you. Two sets of five-way binding posts are provided for each channel to connect to Do not attempt to change this fuse yourself: Unauthorized repairs will the corresponding loudspeaker. The red connection corresponds to the posivoid your warranty. tive (+) input of the loudspeaker, and the black connection corresponds to the negative (­) input of the loudspeaker. Amplifier Hum Dimmer Switch The 8008 amplifier utilizes two large toroidal transformers, so some physical The three-position switch controls the intensity of the blue cascade panel illuhum can be expected. A hum that is heard when you step away from the mination. FULL brightness is all the way to the right; OFF is in the center; and amplifier could be considered unusual, but does not necessarily indicate a DIM is all the way to the left. The power switch must be ON for illumination. Contact your dealer if you have any concerns about A/C Power Connection amplifier hum. Hooking the amplifier up at the dealer's store and comparing it This three-prong receptacle is the A/C power connection, utilizing a standard with the floor model is a good way to verify whether or not what you are expeIEC connector. A/C Fuse Holder This contains the primary A/C fuse. Replace only with the same value and rat1. Plug the amplifier into different outlets (different circuits) in the house to see ing as specified on the back of the amp. if it exhibits the same hum. 8008 MKII RIGHT SPEAKER LEFT SPEAKER S/N LEFT SPEAKER LEFT INPUT RIGHT SPEAKER RIGHT INPUT 11. Power Cord Protection ­ Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience CAUTION: receptacles, and the point where they exit from the product. Overloading ­ Do not overload wall outlets, extension cords, or integral DO NOT OPEN!convenience receptacles as this can result in a risk of fire or electrical shock. To reduce the risk of electric shock and fire, do not 13. Lightning and Periods of Non-Use ­ For added protection for this prodremove the cover or back plate of the device enclosure. There are uct during a lightning storm, or when it is left unattended and unused for no user serviceable parts inside. Refer servicing to an Aragon long periods of time, unplug it from the wall outlet and disconnect the authorized service center. This will prevent damage to the product due to lightning and powerline surges. [. . . ] The red connector refers to the positive (+) speaker connection, and the black connector refers to the negative (­) speaker connection. For proper operation, be sure to connect the loudspeaker to the correct amp output. Either set of binding posts may be used or both sets may be used for bi-wiring. NOTE: Use only insulated speaker wire of an appropriate gauge for all connections making sure that no bare wires touch each other. [. . . ]