User manual KLIPSCH ACT1

[. . . ] Note: Some televisionswill not have an S-Video Input. @ Video Record Output Connect the Video Record Output to the Video Input of the VCR that will be used for recording. ~: Video Record Output may also be used to transmit the video signal to an additional television. Thisallows for viewing two different sources at the same time. I I! @ @ VCRl VCR2 Connect video sources directly as labeled. ~: The above labeling isfor purposes of convenience. [. . . ] The delay display on screen will move one position to the right. To change the delay more than one setting position hold the button down. If you hear any echo, cycle through the settings until the echo disappears. If you need more delay for effect, move to the next position to the right. The delay control may also be used to create subtle "hall" type sound effects. It will make the room sound larger than it really is. ~: Thereare no delay settingsin Music Mode. W W [IJ m Center Channel Volume Controls level of center channel speaker only. Rear SurroundVolume Controls level of rear speakers. 4D Source Select Allows the selection of LaserdiscC, LaserdiscS, VCR 1 or VCR 2 input for viewing on the television. Surround Mode as the recording output. The ACT I is capable of allowing you to view one source while recording from a second to a third source. Forexample; you want to record a movie from a Laserdiscto a VCR but you want to watch the Indy 500. Fromthe Record selector on the remote control pick the source that you wish to record from (be sure that the Record output of the ACT I is connected to the unit you wish to record with!) and start both machines. Then from the Source control select the input that you want to watch (the race) and your ACT I will do the rest! If you need to check the quality of the recording ACTI; Dolby Pro Logic, MusicSurround, and MonoEnhance. Bypass mode isprovided for non-surround simply pressthe "Record View" button. Thiswill give you a view of the "Record" out signal. Forlisteningto material encoded with Dolby Stereo(VHSor Beta hi-fi, Laserdiscs, CD-V, there is a problem just monitor the "Record" output while you track it down and fix it. (Be sure MTS broadcast televisionor Satellitebroadcasts) select the Dolby ProLogicTM mode. The Pro LogicTM to refer to the VCR owner's manual for recording problems. ) Press the button again to return to the will provide active steering of the signalfor more "Source" screen. accurate placement of soundin the listening area and spectacular audio effects. Mute Formonophonic programs, such as movies not The mute button silencesthe entire system. encoded in Dolby Stereo or standardtelevision broadcasts, select the Mono Enhance mode. This Power On/Off mode provides synthesizedstereo for the front and TurnsACT I on and off. With optional RPC-120 synthesizedsurroundfor the rear. Filtered AC Power Switcher attached, this button MusicMode createsa formof surround soundfor can also turn on and off the entire system. [. . . ] 2 Set LISTEN control to TAPE 1, Out of the System 1 Set LISTEN control to any source other than TAPE1, SPECIFICATIONS The following specifications are measurementswhich need not have anything to do with the sound, quality and value of an audio component. The Act I processor was developed with extensive listening. To improve both the audio and video quality, many engineering solutionswere used which will not necessarilybe reflected in the specifications. Separate circuit boards were used of the power supply, video section and the audio section. [. . . ]