User manual KLIPSCH CDT-2650-SC

[. . . ] USE only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. UNPLUG this apparatus during lightning storms or when unused for long periods of time. REFER all servicing to qualified service personnel. [. . . ] Avoid compromising any fire stops between studs. Run speaker wiring (18 gauge minimum) to the openings. Be sure to comply with all building codes in your area. Attach the wire to the speaker using the wire's color coding or markings as a guide to maintain proper polarity. WARNING: Voltages in this equipment are hazardous to life. Refer all servicing to qualified service personnel. CAUTION: Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this device. 4. Insert the speaker assembly into the opening and attach by tightening the four Phillips screws (below). The frame's four "dogs" will swivel out and "sandwich" the wall and frame together as they are tightened. If you use a power tool to tighten these screws, please use a low torque setting. Failure to do so could result in damage to your speaker. 5. Adjust the direction of the speaker by swiveling it to the left or right as needed. If desired, you may also adjust the tilt of the speaker and gently adjust the horn to the desired angle. Do not attempt to turn the tweeter stem while adjusting the swivel tweeter. LIMITED LIFETIME WARRANTY FOR KLIPSCH-BRANDED IN-WALL, INCEILING AND OUTDOOR SPEAKERS Klipsch warrants to the original retail purchaser that this product is to be free from defective materials and workmanship for the life of the product, if it is properly used and maintained. If this product proves defective in either material or workmanship, Klipsch, at its option, will (a) repair the product, or (b) replace the product, at no charge for parts or labor. If the product model is no longer available and cannot be repaired effectively or replaced with an identical model, Klipsch at its sole option may replace the unit with a current model of equal or greater value. In some cases, modification to the mounting surface may be required where a new model is substituted. Klipsch assumes no responsibility or liability for such modification. To obtain a repair or replacement under the terms of this warranty, please contact our customer service group at 1-800-KLIPSCH. You will be required to submit a copy of the original receipt via fax or email. The receipt must reflect that you are the original purchaser, the product was bought from an authorized Klipsch retailer, and the product is still within warranty. You will be issued a return authorization number (RA#) and asked to ship the defective product, together with proof of purchase and RA#, prepaid insured to the address set forth Klipsch 137 Heampstead #278 Hope, AR 71801. Freight collect shipments will be refused. [. . . ] The switch allows a setting of either 0dB (normal) or ­3dB in the respective frequency range. If installing in an acoustically bright room, such as a bathroom or kitchen, you may want to adjust the Tweeter level switch. If the speaker is located in a corner and produces too much bass, you may need to adjust the Mid-Bass level switch. The position of the switches should always be checked prior to attaching the grille. ARCHITECTURAL SPEAKERS OR LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY OR CONDITIONS LASTS, SO THIS LIMITATION MAY NOT APPLY TO YOU. [. . . ]