User manual KLIPSCH COMMSAT

[. . . ] USE only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. UNPLUG this apparatus during lightning storms or when unused for long periods of time. [. . . ] Incorrect connections could result in speaker damage, amplifier damage, or both. WARNING: Voltages in this equipment are hazardous to life. Refer all servicing to qualified service personnel. CAUTION: Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this device. ABOUT YOUR KLIPSCH PURCHASE Thank you for purchasing the Klipsch Comm Sat speaker system. The Comm Sat speaker system is designed for music reinforcement applications. The speakers are engineered for easy, unobtrusive installations and can be used to create a variety of different configurations. Figure 1 2. Install the Comm Sat Speakers and Mounts. First, attach the Speaker to the Mount post (included with the Mount). Simply thread the post into the speaker until hand tight. Now pull the wire pigtail attached to the Comm Sat through the hole in the Mount tube and plate and make your connections in the box behind the plate. Once you have done this, attach the plate to the box. With the adjustment point on the Mount loose, adjust Speaker direction as desired. Tighten adjustment point on the Mount with the supplied tool after the Speaker is aimed as desired. AND CANADA ONLY The Warranty below is valid only for sales to consumers in the United States or Canada. KLIPSCH AUDIO TECHNOLOGIES warrants this product to be free from defects in materials and workmanship (subject to the terms set forth below) for a period of five (5) years from the date of purchase. During the Warranty period, KLIPSCH will repair or replace (at KLIPSCH's option) this product or any defective parts (excluding electronics and amplifiers). [. . . ] WARRANTY­ OUTSIDE THE UNITED STATES AND CANADA The warranty on this product if it is sold to a consumer outside of the United States or Canada shall comply with applicable law and shall be the sole responsibility of the distributor that supplied this product. To obtain any applicable warranty service, please contact the dealer from which you purchased this product, or the distributor that supplied this product. Caution: Attempting to adjust the Speaker direction after the Mount adjustment point has been tightened may result in Mount failure. The Comm Sat is designed to be mounted to the Comm Sat Mount only. Figure 2 3. Install the Subwoofer of your choice, (You may use either the IC-8T-SW flushmount subwoofer or the CA-800-TSW surface-mount subwoofer with this system) following the installation instructions that are supplied with the subwoofer. C O M M S AT N E T W O R K S P E C I F I C AT I O N S COMM SAT NETWORK BANDWIDTH 1 TRANSFORMER TAPS CROSSOVER INPUT CONNECTORS ENCLOSURE MATERIAL HEIGHT WIDTH DEPTH WEIGHT SHIPPING WEIGHT FINISH n/a 70V: 30W, 100V: 60W 100Hz 12dB/Octave highpass Barrier strip Steel 4. 375" (11. 1cm) 6. 125" (15. 6cm) 6. 125" (15. 6cm) 5 lbs. [. . . ]