User manual KLIPSCH IFI

[. . . ] iFi SPEAKER SYSTEM IMPORTANT SAFETY INSTRUCTIONS 1. Install in accordance with the manufacturer's instructions. DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. DO NOT defeat the safety purpose of the polarized or grounding type plug. [. . . ] Store the hex wrench in the bottom of the base cover by snapping it into the speaker base. A similar input on the subwoofer's back panel can also be used with an external source, but it is primarily intended to connect to the audio output of a computer. This input is mixed with the signal from the dock, whether from the iPod or from the auxiliary input so that both sources are heard simultaneously. This allows for, as an example, the sound from your computer to be heard while music is playing from an iPod in the dock. Subwoofer and Speaker Placement Although you can place the components of the iFi system almost any way that is convenient, speaker location will affect sound quality. The subwoofer will generally perform best when placed on the floor in a corner. A good second option is to place it 6 to 12 inches from a wall. The farther it is moved toward the middle of the room, the lower the bass output will be. You will get the best stereo effect with the satellite speakers placed equidistant from the listening position. Wide separation will tend to make the sound more spacious. If possible, avoid locating either satellite closer than two feet from a side wall. If that is not practical, adjust the stands' ball joints to aim the satellites up or down toward the listening position. Stand Adjustment and Wall Mounting The speakers attach to their stands via a ball joint that allows them to be swiveled over a wide range. To adjust the angle, un-snap the supplied hex wrench from underneath the base, loosen the four screws in the clamp plate that surrounds the ball joint. Position the speakers as desired and tighten the four clamp screws. Each stand also incorporates an adjustable down stop to prevent the speaker from drooping after its angle is adjusted. You can access the head of this down stop from the bottom side of the stand. RF Remote Control Your radio-frequency (RF) remote control comes with its battery installed. If you find the remote control is conflicting with another nearby iFi system, see the "Remote Control" section for instructions on synching the dock with the remote control. SYSTEM OPERATION To adjust the subwoofer level, first push the Volume/Subwoofer Select button, then turn the Volume knob. The Light Bar will now indicate the relative subwoofer level. Pressing the Volume/ Subwoofer Select button again will switch the knob back to master volume control. NOTE: When in the Subwoofer mode, the system will automatically revert to master volume after five seconds. Light Bar The light bar on the control dock indicates current master volume or subwoofer level, depending on the setting of the Volume/Subwoofer Select button. [. . . ] Product may only be returned to KLIPSCH after a Return Authorization number has been obtained from KLIPSCH. Returned product must be shipped, freight prepaid to KLIPSCH in either its original packaging or packaging affording an equal degree of protection along with proof of purchase. WARRANTY OUTSIDE THE UNITED STATES AND CANADA The Warranty on this product if it is sold to a consumer outside of the United States or Canada shall comply with applicable law and shall be the sole responsibility of the distributor that supplied this product. To obtain any applicable warranty service, please contact the dealer from which you purchased this product, or the distributor that supplied this product. [. . . ]