User manual KLIPSCH KSP400

[. . . ] The integral stand allows the speaker to be placed on top of the TV (or on a shelf just above or below it) or mounted on the wall (see wall mounting instructions). Ideally, the speaker's front baffle should be flush with the front of the screen. If the speaker is well above or below the ear height of seated listeners, you can improve performance by angling it slightly up or down to compensate. see stand adjustment section for more detail. [. . . ] ABOUT YOUR KLIPSCH PURCHASE Thank you for your purchase of Klipsch satellite speakers. After reading this manual and connecting your system, you will hear the result of over 55 years of stringent engineering and class-leading research and development. Like all Klipsch products, your satellite speakers feature Klipsch Horn-loaded Technology--the guiding design for the first Klipschorn® developed in 1946 and for every product that has followed. Horn-loading allows your speakers to deliver high sensitivity, low distortion, flat frequency response and wide dispersion, which translates to unequaled power, detail and dynamics, the hallmarks of "The Klipsch Sound. " Please be sure to fill out the warranty card at the back of this manual or online at www. Again, thank you for choosing Klipsch and we hope that your speakers bring life to your music and movies for many years. STAND ADJUSTMENT AND WALL MOUNTING The speakers attach to their stands via a ball joint that allows them to be swiveled over a wide range. Each stand also incorporates an adjustable down stop to prevent the speaker from drooping after its angle is adjusted. You can access the head of this down stop from the bottom side of the stand. BUT FIRST: TYPES OF CONNECTORS B a re wire -- Pull the two conductors apart for about an inch and strip approximat e ly 1/4" of i n s u l ation from the end of each. (A wire stripper will simplify this, but you can use an ordinary pocket knife to cut around and through the insulation down to the wire. Screw #8 pan head wood screws (at least two inches) long into a wood stud or dry wall anchors with the ap p r o p r i ate load rat i n g . L e ave the screw heads protruding from the wall surface approximat e ly 1/4" and adjust as needed when hanging the speaker. Remove the center cover from the speaker's base and un-snap the included hex wrench from the underside. Loosen the four hex head screws on the speaker's ball joint assembly and position the base behind the speaker, pointing up the wall. You may need to fine-tune the speaker's angle after mounting it to the wall. Remove the logo from the speaker base by compressing its split post on the underside and rotate it 180° for proper orientation. Hook the speaker base keyholes on the screw heads protruding from the wall. If the speaker will be mounted over the location where the speaker wire emerges from the wall, thread the wire through the hole in the speaker base's snap-on cover by removing the cosmetic plug. Store the wrench in the bottom of the base cover and reinstall it into the speaker base. CONNECTIONS Note: Proper connection of your speakers to your amplifier or receiver is vital to obtaining good sound quality. Klipsch Reference Series speakers are wired internally with Bandwidth Balanced® Monster Cable®. [. . . ] ("KLIPSCH") warrants this product to be free from defects in materials and workmanship (subject to the terms set forth below) for a period of five (5) years from the date of purchase. During the Warranty period, KLIPSCH will repair or replace (at KLIPSCH's option) this product or any defective parts (excluding electronics and amplifiers). For products that have electronics or amplifiers, the Warranty on those parts is for a period of two (2) years from the date of purchase. To obtain Warranty service, please contact the KLIPSCH authorized dealer from which you purchased this product. [. . . ]