User manual KLIPSCH OUTDOOR SPEAKER

[. . . ] USE only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. UNPLUG this apparatus during lightning storms or when unused for long periods of time. REFER all servicing to qualified service personnel. [. . . ] Affix the speaker to the bracket with the supplied knobs. Be sure to leave enough clearance between the end of the bracket and any adjacent wall or ceiling for installation of the knobs. If a wall stud is not available, use the appropriate type of drywall or masonry anchor to support the weight of the speaker, allowing for a generous safety margin. Please consult your dealer, custom installer or building contractor in these situations. You may also use an optional wall or ceiling mount that will fit the provided 3/8" ­ 16 inserts. Please see your authorized Klipsch dealer to see which model is right for you. ABOUT YOUR KLIPSCH PURCHASE Thank you for your purchase of Klipsch outdoor loudspeakers. After reading this manual and connecting your system, you will hear the result of over 55 years of stringent engineering and class-leading research and development. Like all Klipsch products, your outdoor loudspeakers feature Klipsch Tractrix® Horn-loaded Technology--the guiding design for the first Klipschorn® developed in 1946 and for every product that has followed. Horn-loading allows your speakers to deliver high sensitivity, low distortion, flat frequency response and wide dispersion, which translates to unequaled power, detail and dynamics, the hallmarks of "The Klipsch Sound. " Please be sure to register online at www. klipsch. com/register so we are better able to serve you. Again, thank you for choosing Klipsch and we hope that your speakers bring life to your music for many years. CONNECTIONS A Figure 2 The CA-525T, CA-650T, CA-800T and CA-800TSW include a multi-tap transformer for 70 or 100 volt installations. There is also a bypass position that allows normal 8 ohm operation for installations that do not require a transformer. The switch is on the back of the speaker and can be set using a small flat head screwdriver. Make the appropriate tap selection as indicated below: CA-525T (Transformer Power Rating: 30W) 70V: 30W, 15W, 7. 5W, 3. 7W, 1. 7W 100V: 30W, 15W, 7. 5W, 3. 7W Bypass Position: 8 ohm Nominal CA-650T / CA-800T / CA-800TSW (Transformer Power Rating: 60W) 70V: 60W, 30W, 15W, 7. 5W, 3. 7W 100V: 60W, 30W, 15W, 7. 5W Bypass Position: 8 ohm Nominal When making any type of speaker wire connection, be sure to observe proper polarity. Most speaker wire and connectors are color-coded. Typically, red is positive (+) and black is negative (­), or ground. It does not matter which wire conductor is connected to the positive or negative connection of your equipment as long as it is consistent. WARRANTY--U. S. AND CANADA ONLY The Warranty below is valid only for sales to consumers in the United States or Canada. ("KLIPSCH") warrants this product to be free from defects in materials and workmanship (subject to the terms set forth below) for a period of five (5) years from the date of purchase. [. . . ] Wash these surfaces with a moistened cloth dipped into a mild detergent to remove any fingerprints or grease. Care must be taken to mask off the front of the speaker to protect the tweeter, woofer and front panel from overspray. This will maintain the existing uniform dark color behind the grille and protect the woofer and tweeter from being damaged by the paint. Affix masking tape to the inboard wall of the grille groove and attach plastic or newspaper to the tape to cover the entire front panel of the speaker. [. . . ]