User manual KLIPSCH PALLADIUM P-312W

[. . . ] Palladium® P-312W Owner's Manual Important Safety Instructions 1. Install in accordance with the manufacturer's instructions. DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. DO NOT defeat the safety purpose of the polarized or grounding type plug. [. . . ] To defeat this filter, press and hold the Right touch key until "Lowpass Off LFE Mode" is displayed. Refer to your surround processor's owner's manual for more Bass Management information. From this screen, press the Down or Up touch key to access other control settings. Disp Brightness This screen is used to adjust the brightness level of the display screen when the backlighting is on. Use the Left/ Right touch keys to select from the brightness intensities. From this screen, press the Down or Up touch key to access other control settings. Lowpass Slope This screen is used to adjust how aggressively the subwoofer rejects frequencies above the low pass filter's setting. This screen is not visible if the "Lowpass" filter above is set to "Lowpass Off LFE Mode". There are four settings to choose from: "18, 24, 36 & 48dB/octave". The higher the number, the more the upper frequencies are removed from the subwoofer's output. Use the Left/Right touch keys to select the desired filter slope. Start with either the 24 or 36dB/octave setting and adjust from there if required. Adjustment of this parameter can help to optimize the acoustic blend with your main speakers. The proper setting will depend on room acoustics, your main speaker's performance, the placement of the speakers and the subwoofer in the room. From this screen, press the Down or Up touch key to access other control settings. Power This screen is used to select the "Auto On" or the "Always On" power mode for the subwoofer's amplifier. Use the Left/Right touch keys to select between these two modes. When "Auto On" is selected, the subwoofer will automatically turn on when it senses a signal. It will automatically turn off after 20 minutes if no signal is present and the display screen will show "Standby". In the "Always On" setting, the subwoofer will remain on as long as the main AC power switch on the subwoofer's rear panel is in the "On" position. From this screen, press the Down or Up touch key to access other control settings. Phase This screen is used to adjust the subwoofer's acoustic phase to match that of your main speakers. Use the Left/ Right touch keys to adjust the subwoofer's phase from 0°to 180°. The proper setting of this control is highly dependant on room acoustics and the position of your subwoofer in the room. After setting the volume and lowpass controls, adjust the phase to 0° and listen to a recording with a prominent, repeating bass line in your intended listening position. Repeat this process with the 180° setting and use the setting that yields the greatest amount of bass output. [. . . ] To obtain Warranty service, please contact the KLIPSCH authorized dealer from which you purchased this product. If your dealer is not equipped to perform the repair of your KLIPSCH product, it can be returned, freight paid, to KLIPSCH for repair. Please call KLIPSCH at 1-800-KLIPSCH for instructions. You will need to ship this product in either its original packaging or packaging affording an equal degree of protection. [. . . ]