User manual KODAK KD65

[. . . ] GETTING TO KNOW YOUR CAMERA KD60/65 CAMERA (2) ON/OFF BUTTON (1) SHUTTER BUTTON (4) MODE-SELECTION BUTTON (3) LCD PANEL (5) REWIND BUTTON (6) SELF-TIMER BUTTON (7) VIEWFINDER 1 ATTACHING THE WRIST STRAP 3 LOADING THE FILM Need help with your camera?Call Kodak (Canada only) toll free from 8:30 a. m. (eastern time zone) Monday through Friday at 1 (800) 465-6325, ext. 36100; for the Toronto area, call (416) 766-8233, ext. [. . . ] NOTE: The imprinted data may be difficult to read if the subject area over which it is superimposed is bright or non-uniform. If the data panel is consistently dim, replace the date-back battery (see Replacing the Date-Back Battery). MODE/SELECT/SET SERVICE INFORMATION Where to Get Help If you have any questions about your camera or have difficulty in using it, reread this manual and check Troubleshooting. If you have difficulty that isn't covered in Troubleshooting: Take the camera, the film you were using, and any sample prints to your photo dealer OR call Kodak toll free (in Canada) from 8:30 a. m. (eastern time zone) Monday through Friday at 1 (800) 465-6325, ext. 36100; for the Toronto area, call (416) 766-8233, ext. If your camera needs repair, you may send it through your photo dealer or directly to our Service Centre; see WARRANTY. Packing Instructions Using the Self-Timer When you want to include yourself in the picture, use the self-timer feature. Use the Tripod Socket (19) to attach the camera to a tripod, or place the camera on another firm support. Press the On/Off Button (2) to turn the camera ON. The Self-Timer Indicator (26) appears on the LCD Panel (3) and the Self-Timer Lamp (12) glows red. In dim light, such as indoors or outdoors in heavy shade or on dark overcast days, you need flash. Your camera features automatic flash that fires when you need it. Press the On/Off Button (2) to turn the camera ON. Keep the subject within the distance range for the speed of the film in your camera (see table below). Be careful not to cover the flash, lens, and autofocus windows with your fingers. Press the Shutter Button (1) partway down. If the Flash-Charging Indicator (29) on the LCD Panel (3) "blinks, " the flash is not fully charged. Wait for the blinking to stop and the indicator to disappear before you take the picture. Within a few seconds after the last picture is taken, the film automatically starts to rewind. The Picture Counter (27) on the LCD Panel (3) blinks "0" when the film is finished rewinding. Wait for the camera motor to stop before you open the film door and remove the film. Reload your camera with fresh Kodak film. ON/OFF MODE Using the Rewind Button ON/OFF () If you don't want to take pictures on the entire roll of film, you can automatically rewind the film by pressing the Rewind Button (5). 4. Compose your picture and press the Shutter Button (1). The self-timer lamp "blinks" approximately 10 seconds before the picture is taken. After you take the picture, the self-timer automatically turns off. ON/OFF MODE 4. [. . . ] With the data displayed, pressing the select button in succession causes the settings for year, month, and then day to blink. On the data panel, the letter "M" indicates the location for the month and the apostrophe " ' " for the year. In time mode, pressing the select button successively causes the hour, minute, and then the colon to blink. Press the Set Button (d) to change the blinking display. ON/OFF What happened Camera will not operate Probable cause Power off Flash not ready Solution Press on/off button Wait for the flashcharging indicator on LCD panel to stop blinking See LOADING THE FILM Remove the film () ON/OFF MODE () Film not loaded 3. [. . . ]