User manual KOHLER KD625-2

[. . . ] Air Cleaner and Air Intake System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section 5. Electronic Fuel Injection (EFI) System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section 6. Lubrication System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section 7. Electrical System and Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section 8. [. . . ] Remove the oil fill cap/dipstick and check oil level is correct. The correct oil level is between the F and L marks on the dipstick. Oil Drain Plug (Starter Side). Dipstick Operating Range Figure 6-4. Oil Level Marks on Dipstick. 6. 2 Section 6 Lubrication System 4. Place a new replacement filter in a shallow pan with the open end up. Pour new oil, of the proper type, in through the threaded center hole. Stop pouring when the oil reaches the bottom of the threads. Allow a minute or two for the oil to be absorbed by the filter material. Apply a thin film of clean oil to the rubber gasket on the new filter. Install the new oil filter to the filter adapter or oil cooler. Refer to the oil filter for installation instructions. The Oil SentryTM may not shut down a running engine before damage occurs. In some applications this switch may activate a warning signal. Read your equipment manual for more information. The pressure switch is designed to make contact as the oil pressure decreases below 2-5 psi depending upon the application and switch specified. On stationary or unattended applications (pumps, generators, etc. ), the pressure switch can be used to ground the ignition module to stop the engine. On vehicular applications (lawn tractors, mowers, etc. ) the pressure switch can only be used to activate a low oil warning light or signal. NOTE: Make sure the oil level is checked BEFORE EACH USE and is maintained up to the F mark on the dipstick. This includes engines equipped with Oil SentryTM. Installation The Oil SentryTM pressure switch is installed into the breather cover. To install the switch, follow these steps: 1. If no sealant is preapplied, apply pipe sealant with Teflon (Loctite® 592TM PST® Thread Sealant or equivalent) to the threads of the switch. ® 2. [. . . ] Apply a thin film of clean oil to the rubber gasket on the oil filter and thread the filter onto the adapter nipple. Refer to oil filter for specific installation instructions. Add oil to bring the level up to the F mark and reinstall the dipstick. Connect Spark Plug Leads 1. Connect Spark Plug Leads. Prepare the Engine for Operation The engine is now completely reassembled. [. . . ]