User manual KOHLER LV625

[. . . ] OWNER'S MANUAL KOHLER AEGIS® LV625, LV675, LV680 LIQUID-COOLED VERTICAL CRANKSHAFT Safety Precautions To ensure safe operations please read the following statements and understand their meaning. Also refer to your equipment owner's manual for other important safety information. This manual contains safety precautions which are explained below. WARNING Warning is used to indicate the presence of a hazard that can cause severe personal injury, death, or substantial property damage if the warning is ignored. CAUTION Caution is used to indicate the presence of a hazard that will or can cause minor personal injury or property damage if the caution is ignored. [. . . ] Check if the radiator is cool to the touch. Slowly loosen the radiator cap to the first stop and allow any pressure to bleed off. Then fully loosen and remove it. Loosen Screws Figure 13. Carefully tip the bracket away from the reservoir, and lift the reservoir out between the bracket and fan. Pour out the contents of the reservoir and wash out or clean as required. Dispose of all the old coolant properly, according to local regulations. Figure 11. Locate and remove the coolant drain plug in the lower side of both cylinder heads. Drain the coolant into a suitable container. After the coolant has drained, apply pipe sealant with Teflon® (not Teflon® tape) to the threads and reinstall the plugs. Torque the plugs to 13. 5 N·m (120 in. Coolant Drain Plugs Molded Protrusion for Mounting Figure 14. Tipping Bracket Away after Removing Reservoir Cap. Figure 12. The coolant overflow reservoir has 3 molded protrusions (1 upper, 2 lower, see Figure 14) that fit into corresponding holes in the support brackets. Loosen the two screws that fasten the upper bracket to the radiator. Reinstall the reservoir, engaging the two lower molded protrusions in the mounting holes of the support bracket. Engage the top bracket around the upper protrusion. Hold it in this position and torque the screws to 7. 3 N·m (65 in. Flush the cooling system (see ``Flushing Cooling System''). Flushing Cooling System With system properly drained: 1. Fill the cooling system with clean water and a cooling system cleaner recommended for aluminum engines. Reinstall the upper blower housing assembly. Start and run the engine for five minutes, or until it reaches operating temperature. [. . . ] service center as soon as a problem exists. Call 1-800-544-2444 or access our web site at: www. kohlerengines. com for the names of the nearest service centers. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. (c) If you have any questions regarding warranty rights and responsibilities, you should contact Kohler Co. at 1-920-457-4441 and ask for an Engine Service representative. [. . . ]