User manual KOMPERNASS KH 3256 WORKSHOP TOOL TROLLEY

[. . . ] Never work under a raised vehicle unless you have taken additional safety precautions. This is intended to prevent the vehicle from rolling away, sliding off or overturning the jack. Use the product on a solid, level surface only. [. . . ] Using the product on an unstable or uneven surface ­ such as a gravel surface ­ may lead to the load slipping. Ensure that you never exceed the allowable (rated) load capacity. The person operating the jack must observe the jack and the load during all movements. Never work under the raised load if it has not been made secure by suitable means. Do not allow the hydraulic vehicle jack to be used by uninstructed or inexperienced persons. Before using the hydraulic vehicle jack take precautions to prevent the vehicle from rolling away. put the handbrake on , place the vehicle in gear (with automatic gearboxes set to "P") and chock the wheels. Even with precautions in place always remain alert and make a visual check that the saddle 1 is firmly seated against the vehicle jacking point. 1 Vehicle jack 2 Tube sections with locating slot 1 Tube section with locating pin 1 Operating instructions Other uses or modification of the hydraulic vehicle jack shall be considered as improper use and may lead to injury or damage. J lace a tube section with locating slot 6 on to the release valve 5 . p j urn the tube section in the T direction (see Fig. A) until the vehicle moves downwards but not enough that hydraulic oil escapes from the release valve 5 . Lower the vehicle slowly otherwise there is the danger C of injury and damage to the product or to the vehicle. J lose the release valve by turning it in the C direction. J crew the extension screw 2 in the S direction downwards. They can be disposed of at your local recycling facility. Follow these steps: j lace one of the tube sections with a locating slot 6 on to the P release valve 5 and turn it in the direction (see Fig. j ow assemble the three-part pumping lever 8 . [. . . ] j ow assemble the three-part pumping lever 8 . Turn each tube N section 6 7 in the direction to fix it in place. j lace the hydraulic vehicle jack under one of the lifting positions as P shown in the owner's manual supplied by the vehicle manufacturer. [. . . ]